Toshiba Repair Tips
Search: toshiba
Results: 5592
Results: 5592
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
S-TOSHIBA |
TV2056M
|
No characters (osd) | 100k 828 resistor close to the flay | willamis - |
|
TOSHIBA |
U14
|
Rounded blue screen at the top | Deflector coil | Replace it with another one and the TV worked normally | ANTONIO DO RADIO |
TOSHIBA |
TV- 2086 LMS
U16 |
Burning horizontal outlet | C 440 measuring in good condition. | Replace the same. | Igor Almeida |
TOSHIBA |
3488
|
No sound adjustment (high volume) | Changed ae-eprom | javan | |
TOSHIBA |
TV2090 U14
U14 |
Power supply inoperative - no secondary voltage | Resistor r876 (220r smd) open - in line of strw5753 over-current protection | Replace resistor | Wender BF |
TOSHIBA |
2089
U 14 |
It takes a while to turn on and when it turns on, it turns on, + without sound, then turns on with sound | Cap 887, replace directly without measuring. | fernandoferreira | |
TOSHIBA |
2981
LEM7 |
Vertical closed | Cold welding q830 and q301 vertical output | beto2828 | |
TOSHIBA |
TV 2096JMS
U14 |
Does not turn off on the control | R 437 | Replace this resistor from 10k to 4k7 | |
TOSHIBA |
TV2093JAV
U14 |
Transistor q430 is overheating | Doesn't start | mauricio | |
TOSHIBA |
TV2157 AFS
|
Dark image, screen does not work | Change capacitors, 902,931,900 even if it is worth replacing with new ones, especially the capacitor (902) | (willamis) |
|
TOSHIBA |
TV14A82
U8 |
Closed vertical. however, after a few minutes the image started to open (depending on the fault, the image may not open). | C 301 1uf x 50v. | Tec Vídeo | |
TOSHIBA |
2958HFS
LEM8-F56 |
I received 2 tips..the second was the one. I removed the q.432 and the TV started working again. | Low power supply at b+ with 77v. normal primary. | I received 2 tips..the second was the one. I removed the q.432 and the TV started working again. | hoifman |
TOSHIBA |
TV-2999KMS
|
Turns on and then turns off | Replace d 101 33v and d 420 4v7 in short | Eronaldo | |
TOSHIBA |
M1490
U14 |
TV only has 78v on +b, after changing the q404 | Q403, in the test it is ok, replacing it with another one worked | Dj carlinhos | |
SEMP TOSHIBA |
TV 2084 GAV
|
Weak color | Smd resistor with changed value | Substituir r 928 smd | paulo artur rio de janeiro |
TOSHIBA |
TV2958GFS
LEM 7 FS2A |
Dark image, even adjusting the screen it remains dark | C902 3300/2kv na placa do trc | Confirming the tip from my colleague Cesar from Unitec, this cap has to be replaced, there's no point in measuring. It was just a matter of changing it and everything worked normally. | EPATEC-ES |
TOSHIBA |
TV- 2056 M
|
Tv turns off | I solved q 805 q 806 and next to them and the TV worked normally. | jaironuness | |
TV- TOSHIBA |
T 2091 U14 R
U 14 R |
TV takes time to turn on. | Changed the c- 879 4.7/ 63 volts | jaironuness | |
TOSHIBA |
TV 2082 EAV
U6 A |
Technical information about defect without OSD or without characters. | Check the r 828 of 100 k. check c- 820 - 100/ faulty check c- 821 680/ faulty check q821- 2sc 1740 or 2sc 1815y faulty note: the collector of this transistor receives 4 volts that come from r 801 of 10 k this r 801 receives voltage from pin 5 of q 840, check faulty r a o 1 of 1 k. | jaironuness | |
TOSHIBA |
TV-2987 FMS
LEM 3A |
Tv doesn't work | Changed the horizontal output transistor | jaironuness |