Search: toshiba
Results: 5617
Make Model Symptom Problem Solution By
TOSHIBA 261S4B
Width - excessive. Raah1.
TOSHIBA 259D9B
No sound from cold Replace 470µ smoothing cap in 12v supply in psu near loptx
TOSHIBA 259D9B
No sound & o/p ic getting hot An7171k o/p ic & check 10µ elects in cct
TOSHIBA 259D9B
No sound Sound o/p chip an7171nk blasted due to hi volts caused by c866 & 869 10µ 50v in psu pri
TOSHIBA 259D9B
Int. sound Q196 int. open
TOSHIBA 259D9B
Int Dry joint on qg16 5v reg on nicam pcb
TOSHIBA 259D9B
Int loss of sync Dry joints icf01 ic on txt panel
TOSHIBA 259D9B
Field foldover C313 220µ
TOSHIBA 259D9B
Dead - st/by led flashes D19
TOSHIBA 259D9B
Dead C820/838/840/844/845/846/847/501/866/869 plus the the 2sd1279 at 8ukp(seme) the 5.6Ω 20w surge limiter, q802 a 2sa1012 after all this the power supply ran but was obviously under stress - c462 2700pf 2kv s/c
TOSHIBA 258T7B
Poor contrast. Da70 ( in4148 ) o/c , r549 ( 470r )
TOSHIBA 258T7B
Off with whistle from psu D820 s/c also replace c820/838/840/844/845/846/847/501/866/869
TOSHIBA 258T7B
No tuning , just snow , no osd Db01 5.1v zener
TOSHIBA 258T7B
No raster- may be int. Drys on p570 scan coil connector ( p no: 23305501 )
TOSHIBA 258T7B
No luminance on teletext. D204 ( in4148 ) o/c.
TOSHIBA 258T7B
Loud screeching at sw on - fades out when warm 12v supply to audio sect high - c866 & c869 10µ 50v
TOSHIBA 258T7B
Flashing or negative picture. Cv03 ( 0.01u f )
TOSHIBA 258T7B
Field jitter. D301 ( in4148 ) o/c.
TOSHIBA 258T7B
Field coll safety res oc Tda8145 sc on dpc pcb
TOSHIBA 258T7B
Dead with puff of smoke C646 2700pf 2kv in lop had split