Toshiba Repair Tips
Search: toshiba
Results: 5617
Results: 5617
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
TOSHIBA |
20"
U10 |
Vertical white stripe with channel number in the middle and thin stripes at the top, when I solved this problem the April TV had little contrast. | Vertical- capacitors, c-305 of 1m/50v and c-306 of 2200m/16v, in contrast- it was the r-227 of 33k. | Replace components | eletronica vinisom e tv |
TOSHIBA |
TV2934
|
Normal operation, power supplys ok, after a few minutes the television starts to turn red until retraction lines appear and the screen is completely red | 270r resistor r514 opened or altered, it remains on the kinescope board | WAGGUINHO | |
TOSHIBA |
TV 2956 HFS
FS6 |
Another time it wouldn't turn on, the stand bay would blink | C-819 of 47x50v is behind the power supply str | Just replace it for another of equal value. | ELETRONICA CAVALCANTE - MARTINOPOLE-CE |
TOSHIBA |
U 17
LME |
LED turns on and off | Vertical output tda 9302a replaces with tda 9325a or tda 78040 are the equivalents | I replaced the 9302a, I put the tda9325 and blz. | luiztvsom |
SEMP TOSHIBA |
TV2134(B)SL
SK11 |
It doesn't turn on, it keeps hitting the relay | Which can be | francisco pereira alves | |
TOSHIBA |
TV2159(O)FS
U19 |
Completely blue screen, then turning off and very low audio. | Cause transistor q652 smd not testing direct replacement. I removed the q906 smd on the rgb board for testing and appeared in the image with low sound. | edsomvideo | |
TOSHIBA |
TV-1451
U18 |
No video | Resovido dz-613/dz-418/r-447-4k7-1w | ZEZINHO | |
TOSHIBA |
1456M
|
Turns on normally with sound and image, but without OSD | I found the broken track that comes out of pin 41 of the ica01 | ROBERTO PINTO | |
TOSHIBA |
1456M
|
Normal alloy with sound and image, but represents a black stripe at the top and bottom. | I found the chapter. 316 3300x16v. with low capacitance. | ROBERTO PINTO | |
TOSHIBA |
TV2957 FS
LEM FS1 |
TV with menu acting all the time | Remove the sima keyboard cable from the power supply | adriano SB | |
TOSHIBA |
TV2999KMS
LEM7FS2A |
AV channel blocked | Service mode press key s + channel + until the TV turns off and on by itself | ELETRONICA MAURI JUNIOR | |
SEMP TOSHIBA |
TV2177
SL-11 |
No video, dark screen and normal audio | C 423 open, d423 short | Replace c423 and d423 | NARDINHO-ALFENAS |
TOSHIBA |
TV2957 FS
LEM-FS1 |
TV with rounded image closed in the center | Resistor (smd) rd07 open or altered | Replace the same | adriano SB |
TOSHIBA |
TV2015MM U17
|
It ends up with a white screen but with a wave-shaped frame and a line in the middle, appearing vertically closed | Replace c884 220y160v | Fagali | |
TOSHIBA |
TV2916NMS
LEM10 |
Does not turn on LED turns on and off | C819 10/50v | Replace below capacitance | LUCIANO |
TOSHIBA |
TV2134
|
Reduced vertical. 10 cm strip in the center of the screen, side deformed. | D-301 open. | py1acb | |
TOSHIBA |
TV 215MFS
U17 |
TV doesn't turn on, the LED turns on, it just stays on standby. | +b 115 voltage only gave 75 v. in the collector of the horizontal output, voltage q432 at the base 0v, in the collector 9 v, normal voltage 5v, however the voltage of q405 in the collector was 13 volt, in the emitter 2 v. I put the horizontal output in short, I put in another d2624, however tsound was a small leak in the emitter with the base, so I put in the bu2506df, it worked normally. | Saida horizontal. | ELETRÔNICA MOISES NH |
TOSHIBA |
2134SKY
SAM/TOKO |
Image with excessive brightness and does not adjust | Electrolytic 4.7 250volt-c329 | Replace | luiztvsom |
SEMP TOSHIBA |
TV1484AV
U13 |
If it turns off, it doesn't turn on again, when the test tip touches the primary power supply it starts | Str g5635 | luis carlos [nene] | |
TOSHIBA |
TV2095 KM
U15 |
TV with bluish screen and shadow of characters | TV with spot killer board defect | Remove it and leave it alone. | adriano SB |