Search: toshiba
Results: 5591
Make Model Symptom Problem Solution By
TOSHIBA 1451U18
Verde Q906 replace Replace q906 on tube plate eletronica ceara
TOSHIBA TV29A87
Works normally but does not show characters (osd) Trail close to the vertical ci oxidized APOLO T.C.
TOSHIBA TV-2134
SK-11
Very strong buzzing on the flyback a waveform on the sides Replace c-317 47/uf/160v JNETO GOIANINHA
TOSHIBA TV-2050
U17
No sound no video when using rgb reg. Check the regs. position r-413 r-840 both are 2k2 per 1/8 w JNETO GOIANINHA
TOSHIBA 2122FS
U19
TV with closed vertical Check all voltages of the vertical IC and all resistors (smd) r306/307/313/316/301 Check all resistors (smd) r-306/307/313/316/301 or vertical ci adriano SB
TOSHIBA TV2177SL11
TV burning primary fuse Str w6554a/ diode bridge Replace the two components but analyze all areas. adriano SB
SEMP TOSHIBA TV 2091 KAV
U15 U14 U17
When turned off by remote, it erases and returns only image Does not cut the +b 9v on stand by Q 432, dtc 123jk open, replace jasvan souza
TOSHIBA TV2997 BSU
TG-1H6
Whining, sparking sound. Pin 15 of the ci decoder qg 01 did not have the 0v indicated in the diagram, and when measuring it the sound was normal. Replace of the 15k RG 15, which was open. jasvan souza
TOSHIBA TV2988
LEM8
Si.shutting down.vertical closed Diode,301 open jps.elet.c.grande
TOSHIBA TV2070
Without horizontal and vertical synchronization C 104 of 0.22 /50v changed Henderson(hndrsn)
TOSHIBA TV 2999KMS
LEM7
No weft LED flashing fast D 440 shorted. After changing, r 432 was smoking, q430 was also shorted. As we couldn't find an original d440, I added a replacement. It didn't hold up, so I sent it to the store. I bought a 4 amp pestiado, oh yes. it worked. Replaced d 440, q430, everything ok Djalma de Oliveira
TOSHIBA TV 2083 FAV
U11
Green screen with retrace lines Defective microprocessor Replaced it, and the TV was broken Eletrica Express
TOSHIBA TV 2083 FAV
U11
Só stand by Varicap - shorted Replace of the same Eletrica Express
TOSHIBA TV2998CSU
Turns on then turns off and the LED stays on I noticed that when I turned it on it generated and made a strange flayback noise and then it remained on stand-by. Changing the deflector coil as it was oxidizing internally. HIPERELETRONICA SERVICE (MARCELO MARAIAL-PE)
TOSHIBA TV2092LAV
U16
When pressing the power button, the TV does not turn on, stand-by is off, +b = 0 volts, normal primary 160v in the filter. Replace broken q801 (str-w5753a). TECNOGUEDES
SEMP TOSHIBA 2916/NMS
U-10
Smudged or blurred screen Does not arm the relay to activate the tube coil Resolder the sr 81 relay pins Ademar / Videira sc
TOSHIBA TV2158NFS
U18
Blinking LED and +b 45v, normal is 113v Ceramic capacitor 10k(103), position c865 with leakage After changing it, the TV worked normally HIPERELETRONICA SERVICE (MARCELO MARAIAL)
TOSHIBA TV 2159NSF
U18
Image with a lot of brightness and little contrast appears to be blurred C446 (4.7x250v) without capacity Replace for a new one and invoice Claudio Jd Paulista Bx
TOSHIBA TV2959IFS
Dsleague; dsleague; dsleague... I'm bored Right hand wheel 100 This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA TV-2959
Power supply arms and disarms after 2 seconds with a small noise in the traffic, re-arming only when c-810 discharges. C-819, 47µf/50v. replace. py1acb