Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TV TOSHIBA	TV2083FAV U11	Turns on with white screen no video no sound no osd	Broken memory replace		darci fuhr ivoti rs
TOSHIBA	2050 MAV U17	Clear screen without sound, image, characters and closing on the sides.	+5 volts low at the emitter of the q840 at the base and normal collector. with leak.		edsomvideo
TOSHIBA	U15	Doesn't work	Smd resistor 876 (220) open		sonivideosva@hotmail
TOSHIBA	TV 2177	When it heats up, it forms a vertical weave from bottom to top.	Vertical and horizontal deflection coil	Replace yoke	ELTON CASTRO - CABO -PE
TOSHIBA	2999 JMS LEM 6	Dark curves on the sides	Image with dark edges on the sides in the form of a curve qd01 practically shorted, make the change.		Adilson39
TOSHIBA	MS7904MU	Cd inoperative (when you put it in the cd function, only the name "cd" appears on the display	D500 (1n4001). see if the 5 volt voltage from the regulator passes through diode d500 and drops to around 4 volts.	If no voltage passes, replace the diode with one (1n4007).	Eletrônica Áudio e Vídeo - Quixadá/Ce - Téc. Wanderlei Studio
TOSHIBA	TS-149 CR	Does not increase volume	Da33 open diode ba318		Henderson(hndrsn)
TOSHIBA	2916 MMS LEM9	Tube with a pinkish stain on the blue screen, when applying a signal the image turns green at the location of the stain.	Magnetized tube.	After cleaning, visual inspection and re-soldering the board, carefully: take a very large speaker magnet and pass it over the stain, removing it from the edge of the tube. In my case, it was amazing!	RONDINELE Campo Redondo-RN Serviço Especializado Semp Toshiba.
TOSHIBA	TV 2916MMS LEM9/FS7	The TV turns on the LED and turns off, it has 5 volts, it has 8.5 volts. horizontal starting, but the high power supply 130v, had it, but when it started it died dropping to zero volts.	Electrolytic capacitor 330 microf/160v open (c884).	C884 330 micro/160 volt open	ELETRONICA MOISES NH
TOSHIBA	TV2091JAV U14	According to the customer, the TV started closing the vertical after using it for a while, the TV went out, when it arrived at the workshop, the LED turned on, it started and the LED turned off, then unplugged it, put it back on and it didn't even light up until some time later.	C-306 of 1000/16 and q-301 stv9302a	Replace the capacitor with the same or higher voltage and the IC with the same or tda9302h.	eletrônica vinisom e tv
TOSHIBA	TV2958	Oscillating width	C416 10uf x160	Replace c416 10μF x 160	celito santo angelo
TOSHIBA	TV2134 SK11	Flashing on and off enlarges the screen and reduces the frame with lines	Q606 (8050)	Replace the same	eletronica godoy
TOSHIBA	TR-7046 MICRO SYSTEM	I'm sound	Defective headphone jack	Solder the pins to the board and zefiní!	Ádrian Chapadão do Céu-Go
SEMP TOSHIBA	20A82EAV U8	Does not turn on, only stand by	C306 2200mf/16v vertical output position, shorting, weapon protection	Replace the same	MACHADOR7
TOSHIBA	TV 1484 U12	Blue screen with no characters	Q906	To remove	juci
TOSHIBA	TV 2998 EMS LEM 2	After a while on, the image keeps shaking and closing vertically	Q 830	Replace without testing q 830. replace with tip 31c	DEBIQUE
TOSHIBA	TV 2916 MNS LEM-10	This TV arrived at the workshop with a faulty power supply, we put the strw 6554-a on it and it didn't work, it came from another workshop	Strw 6554-a and a 220 resistor, located on the r 876 board.	Now just run for the hug	OP Eletrônica(Ozenildo)
TOSHIBA	U14 U 14	TV doesn't turn on, just stays on ST by power supply + - 74v causes c 887 100uf 35v weak _ the same stabilizes power supply as q 430	TV doesn't turn on, it just stays on st by voltage of + b is around 74v voltage on collector of q 430 below 8v causes c 887 100 uf 35v weak		por color tec mauá sp
TOSHIBA	2083AAV U9	It doesn't turn on. and when it does turn on it shows a black stripe at the top and bottom	Electrolytic capacitor c884 (220/160v) with one of the pins broken. c301 (1/50v) damaged q301 (damaged tda8403k	Replace the mentioned components	gilmar84
TOSHIBA	TV2998FMS LEM3	Dark stripe at the bottom vertical	C305 1 micro x 50v exhausted	This TV arrived at the workshop with a power supply defect that was resolved, however the TV worked normally with a one centimeter band at the bottom of the screen that gradually disappeared, I went into service mode but tried to adjust it but it didn't work, including someone I had already replaced the vertical amplitude, when testing c305 it was exhausted, after replacing it and remaking the adjustments the TV was normal	ivan@