Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	TV1491 TV2091 TV1488 TV2088 TV2086 TV2089 TV1495 TV2095 TV2096 U14 U14R U15 U16	Doesn't start.	Power supply	Fuse, q801 strw5753a, zener d876 (5.6v), r876 (220)	R-TEC Eletrônica
TOSHIBA	TV2998	Dead	Replace r2r2 strw6554	Replacement	fco vila rica
TOSHIBA	TV2982 LEM8	Vertical closed	Cold soldering on q830	Resolder or q830 +5v-2 regulator	jedvaldo
TOSHIBA	2959 FS LEM9	Doesn't start	After research, we found that the horizontal output was burnt due to the d440 diode leaking. After changing the components, the TV worked with a cushion effect. We replaced the fly back and deflector but the defect continued.	After a long research, we replaced the memory (eprom) and made the adjustments in service mode and the TV started working normally again.	Paulo e fabio
TOSHIBA	2959 FS LEM9	Doesn't start	Horizontal output burned out because the d440 diode was leaking. After replacing the components, the TV presented the pad defect, we tested the deflector and fly back and verified the memory	After exchanging the components, the TV presented the cushion defect	Paulo e fabio
TOSHIBA	2999 LEM8	High power supply	C819 (on the heatsink side of the power supply)	Touching without measuring (no replace appeared on the capacimeter) and runs for the hug.	R-TEC Eletrônica
TOSHIBA	TV-2958 FFS LEM - FS3	Image with noise and horizontal jerk	Electrol capacitor. c 180 = 1 x 25	Replace and smile	wilsomtv
TOSHIBA	2083FAV U11	Completely out of sync	Diode 431 open		lázaro lemos
TOSHIBA	TV2998 LEM-5	LED is on and won't turn on	R874 in front of open power supply regulator	R874 110k	Ádrian Chapadão do Céu-Go
TOSHIBA	TV1451 U18	Alloy with green image and reduced frame without characters	Q841 short	Replacelo	antonio nobrega patos pb
TOSHIBA	TV1030 U19	Dead power supply	Ci strw5453c short	Replacing the strw5453c with strw5753a, just invert pins 4 and 5 of this and then jumper pins 3 and 5, just and only and it's ready. It works perfectly, you don't need to add or remove any components, just jam it. see the diagram and compare to understand. Note: installed and tested	jedvaldo
TOSHIBA	TV-2982 MAV LEM9 LEM9	TV with LED access with tic tic on the power supply	Resistor r878 e flay back	Check the resistor r878 or flay back in my case the flay back was bad, I replaced it and went to the hug.	AdrianoSB
SEMP TOSHIBA	TV2959JFS FS-8 918760	After a few minutes on, the colors became distorted and stained (blue, red, green)	Problem with the demagnetizing coil relay	Resolder the relay legs (it's good to take advantage of the TV being open and resolder everything)	FABIANO FONTOURA
SEMP TOSHIBA	TV2134B SL SK11 SK11	Chinese varicap (tdq-6ft/13f9s), cannot be found in any replacement store	Swap for the varicap tecc1040pg38p (samsung) which is used in the philco tp1454, works perfect. Note: tecc1040pg32t was also tested but did not pick up some VHF channels.	Replace and go for the hug!!!	EDGAR THIZ
TOSHIBA	U16	Dark image	Polyester from a. voltage on the tube plate.		Djalma de Oliveira This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	2922 JFS	When turned on, the LED would light up and go out immediately, leaving the power supply with a lot of charge.	C-819 of 10x50v changed	Replace for another	ELETRONICA CAVALCANTE EM MARTINOPOLE-CE
SEMP TOSHIBA	TV2134	Reduced frame on both horizontal sides and vertically at the top and thin white lines vertically	Q-302 (stk-630)	Replace transistor without testing.	eletrônica vinisom e tv
TOSHIBA	2998 LEM4	When it turned on normally, after a while, green predominated....I even thought it was the tube...	I resoldered r960 and it was normal.		joosias
TOSHIBA	TV-2177 SL-11	Loud whistle at the fountain	R888 from 4k7 open close to str		July Herbet
TOSHIBA	TV2157FS U17R	No audio on the av, in normal tuning	Corrupted eprom data, even re-recording the audio on the av did not return	Modify in opt2 (22) to 82 , in d1 development mode	VipCenter