Toshiba Repair Tips

Search: toshiba
Results: 5592

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	TV2082-BAV U8	Dark band on the left side of the screen, image offset to the right.	D302 ( zen. 12v) as high fuga		Manoel (Noca)
TOSHIBA	TV 2982 29	TV without power supply inoperative	R 874 220k aberta		negodrama
TOSHIBA	TV2958 GFS U7	Completely stopped, stand by LED on, power supply voltages all normal, fuse f470 open when replacing resistor rd02 [6.8 r/ 2w] burns and the fuse opens again.	Dumper diode d440 [erc06-15l] shorted.		Altevirlima_Valparaiso Eletrônica_PA
TOSHIBA	TV 2998 (F) MS LEM 3A	Takes time to call. It has a flashing LED and a pulsing sound.	The power supply was oscillating and took a while to stabilize. the filter capacitor c872 33uf/35v had low capacitance. Just change it.		Gilcimar Rocha Pereira
TOSHIBA	TV2177 ASL SL-11	Not working	Ci str-w6554a	Barter it	Hipereletronica service (MARCELO)
TOSHIBA	TV2958FFS LEM-FS3	Wide image, characters extending beyond the sides of the screen.	I found cd11g 10uf/100v electrolytic capacitor next to the deflector connector, hugs and good luck to everyone.	They say tsound is no solution to death, it's because they don't know the promises of Christ our Lord, I believe that we as technicians should be united partners and not selfish and individual but that's it, a hug to everyone.	This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV2082-BAV U8	Image shifted to the right, black band to the left of the kinescope	1k r-402 (check the 400 line)		Silva
TOSHIBA	TV2134 SK11-SK91	TV with very wide image, after a few minutes of operation it turned off...	Power supply very altered with around 138 volts, r633 of 220k changed to 270k, I changed it and it returned to normal...		neilson nicacio (sonivídeo assistência)
TOSHIBA	1490 U13	When turned on, tsound is a flex on the screen, but the filament does not light up	C440 (5n1), without capacitance well below.	Replace it.	J.Dantex
TOSHIBA	TV 2987 KAVS LEM 7	Screen reduced in the vertical direction even though I checked the circuit and also through the service mode, without success	After several attempts, I solved the problem using the schematic, the eeprom that was on the board was 24wc16 and not 24l04 as shown in the schematic, I placed the eeprom 24c04, the screen opened completely and then I just had to enter service mode to make the horizontal adjustments and vertical that were a little expanded	Eeprom 24c04 (solved)	JOANILDO SILVA
TOSHIBA	T V 2997 SU	The TV turns on with no video, no characters and no audio	In my case the reset voltage was slightly below normal	A 10 k ac 25 capacitor with leakage on the 5 volt line	macedo domingos
TOSHIBA	TV1450MAV U17	LED access and it wouldn't start I tested the horizontal on the plate it was fine when I took it off the plate one side was open	Bu 808 th	Replace for the original	ELETRONICA CAVALCANTE MARTINOPOLE-CE
SEMP TOSHIBA	TV-1480	TV turns on and channel keeps changing randomly	Ca78 connected to pin 37 of the micro	Replacelo	ELETRONICA ELETROSONIC
TOSHIBA	1495 JM U 14R	I'm sound	Q611	Remove, works without it.	J.Dantas
SEMP TOSHIBA	2087 U11	Tv without red	Re: tv semp toshiba tv2083fav chassis:u11 color blue and green tsound is no red. message by naldo oliveira on Tue 20 Jul 2010, 12:53 enter service mode(s) and after mode(s) enter mode(d) and reset the eprom. service mode(s) press the mute key on the remote control and observe the inscription "sound off on screen" on the TV. Press the mute button again and, keeping it pressed, press the menu button on the television panel. the letter "s" development mode (d) with the television in s mode press the call key on the remote control, and keeping it pressed press the menu key on the television panel. Note: To exit service mode or development mode, turn the TV off and on again. reset the television must be in service mode press the call key on the remote control press the call key again on the remote control and without releasing it press the ch + key on the television panel and wait for the tv to turn off and on again.		heliomar This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	2997	Rosy image	R 902 open		flad8
TOSHIBA	TV2159 U18	Bluish fabric erasing	Q 906	To remove	Alvaro (prolar)
TOSHIBA	TV2916MMS	Due to lightning the TV stopped.	Power supply stopped working, q801 defective.	Q801=str w6554a was replaced and resolved.	Armando Eletronica EvoluSom
TOSHIBA	TV2157BFS FS2A	Tsound were times when it would turn on and then it wouldn't turn on but the LED would come on and go out slowly	C- 47x100 is behind the power supply str	Replace it without measuring	ELETRONICA CAVALCANTE MARTINOPOLE-CE
TOSHIBA	1470	LED access, but does not turn on.	Solution: replace zener diode (808)		BARRETO CRUZ