Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	U16 JOSE FERREIRAS	It heated the horizontal outlet until it burned	I changed the flay and put a capac. 100k x250v in place c. 463 and the bu808dfi and everything resolved		jose ferreiras
TV TOSHIBA	2083	Vertical closed	When turning on the high voltage device, a reduced horizontal line appears on the screen for a few seconds and then the stand bye starts flashing.	C 713 was replaced with a low value and the vertical ci ic 601 was shorted. It's also good to see the high voltage capacitor on the horizontal line. the TV was ok.	BF.COLATINO
TV TOSHIBA	TV 2159OFS U19	Relay knocking and won't turn on	Ci q501 short and r227 open.	Replaced and resolved	BF.COLATINO
TV TOSHIBA	U-16	Takes time to call	The defect was resolved by replacing c 419		BF.COLATINO
TV TOSHIBA	2982 AVS LEM 9	Dark image	As time went by the image darkened, within a few minutes (about 15 minutes) it was so dark that nothing could be seen anymore.	Replace without measuring the capacitor c 902 which is on the kinescope board (it filters screen)	BF.COLATINO
TOSHIBA	U15	Lying horizontally, lack of synchronization.	I thought it was a capacitor but it wasn't.	I simply replaced the 24c04 smd memory and it worked.	BF.COLATINO
TV TOSHIBA	2985	Shortening only the sides. Sometimes, these sides formed a half moon with the rounded part facing inside the screen.	The sound also disappeared (sometimes on one speaker, sometimes on both). and the screen would also become whitish or dark.	Defect resolved: 1- hitting the sides: c 880 replaced (3300 x 35) and v 445 dry (4.7 μF)	BF.COLATINO
SEMP TOSHIBA	2085FM	Very open vertical	I found the c884- 22uf/160v dry, I replaced it and it worked normally.		BF.COLATINO
TOSHIBA	TV2177SL U11	Blowing secondary fuse and horizontal output	I checked the power supply and it was altered, measuring 175v, the normal value is 126v.	The r-851 was measuring 300k, wsound its real value is 220k, just replace it and go for the hug. The horizontal outlet was also replaced.	BF.COLATINO
TV TOSHIBA	TV 2083 U11D2	Colorless and whitish	4.7mf/250v rgb line capacitor		BF.COLATINO
TOSHIBA	TV2080	Characters running flashing	Ra.03,10k		julio itaguai
TOSHIBA	2084-G U12	Dead	R810 (3r3) open // q801(2sk3508)shorted	Replacement made, defect resolved	JDANTEX
TOSHIBA	TV 1491 J A V	The TV only has the LED on in stand by, +b normal and not starting.	Q 430=c 3209 ,defective.	I replaced it and it was beautiful.	Armando da Eletronica Só tv de Olímpia.Est:sp.
TOSHIBA	TV-2999JMA LEM-6/FS2	The stand-by turns on, but it takes a while to turn on the high voltage, then it comes with a dark screen, no sound and no characters	24c16 memory replace		FERNANDO S
TOSHIBA	TV2177 SL11	Horizontal burning, high power supply and disarms	Horizontal output transistor and power supply optocoupler	Replacing them	paulo eletronica
TOSHIBA	MS-7520MU	Look at the cd	Check voltage 5v q502 if not change without measuring		Sidney Alves
TOSHIBA	TV 2092 U16	Does not turn on or light up LED	Main power supply does not oscillate without secondary voltages	Smd capacitor pos:c877 replace it and blz	KAIRO DIGITAL TEC
TOSHIBA	TV2159 U18	Vertical closed	Res 885;0.22r changed		jacksson
TOSHIBA	TV2998FMS	The horizontal output burns when turning off the remote control, but it doesn't burn if turned off via the socket, the power supply is normal	Integrated circuit tda 16846		simas433
TOSHIBA	LC 15/2010Z	Power supply does not start	Check on the PCI main stage of the power supply if the electrolytic capacitor c356 is altered or has unsoldered terminals.		Miltom eletronca micro e eeprom