Vestel Repair Tips
Search: vestel
Results: 169
Results: 169
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
VESTEL |
11AK19
11AK19 |
Does the power no. red LED turns green, but without mat | It had a line transformer with mat leaks. after changing the t.l. left with this defect. ic 401 pin 12 (8v) in dc. | Replace ic 401, | jose luis calcada |
VESTEL |
11AK19
11AK19 |
Does not switch to av | Q504 | Replace q504 bc558 | jose luis calcada |
VESTEL |
11AK19
11AK19 |
Does not power on. red LED turns off | Q500 | Replace q500 bc548 | jose luis calcada |
VESTEL |
11AK19
11AK19 |
No e/w correction | R629 burned. normally caused by a change in l602 1mhy (3002026). also check the c630 .43uf | jose luis calcada | |
VESTEL |
11AK19
11AK19-E3 |
Does not power on. red LED turns off | 8v regulator, has 4v | Replace 47μF/250v capacitor in secondary | jose luis calcada |
VESTEL |
11AK08
|
Out of phase | D802 with leak | ||
WATSON - VESTEL |
WATSON FA6339
|
Does not start - front LED flashes quickly at half brightness | Replace r867 which was over 30kΩ | ||
VESTEL |
CH 11AK19
|
Subst ic tda 8840 1y >> 2y | In service mode, correct the setting "04" if-pll, example 62 >> 75, also "03" agc, 28 >> 20 | ||
VESTEL |
7298NT CHASSIS 11AK12-9
|
The image gradually shrinks horizontally until it is just in the middle of the screen | Change 10m r441 with changed value on the 33v line | ||
VESTEL |
7296 CHASSI 11AK12-6
|
Vertical with lack of amplitude | R441 of 10m changed even with approximate value (replace it) | ||
VESTEL |
CHASSIS 11AK19 C/ MC44604P
|
"grila" em st by ... | R816 (1.5 mΩ) open | ||
VESTEL |
7299ST CHASSIS 11AK16-2
|
E/w issues and rgb lines at the top of the screen. | Replacement of the tda8376 ic to repair the e/w and r714 for the lines problem. | ||
VESTEL |
CHASSIS 11AK19E3
|
LED flashes weak green. low voltages and pulsating (+b 40v) | R867 0r33, d871 zpd12v | ||
VESTEL |
11AK19E3
|
High power supply around 180v, not adjustable with the potentiometer. | Replace broken r823 | ||
VESTEL |
VARIOS
|
In models wsound tsound is a spike on the lid that will touch the tranf. lines next to the mat outlet, in dusty and humid conditions it causes serious leaks | As a preventive measure, cut the spike | ||
VESTEL |
5166 - 11AK10-15
|
Power supply tr q801 burnt out, burns again as soon as the switch is turned on. | R805 open. | ||
VESTEL |
CHASSIS 11AK19E3
|
Does not work, tsound is no voltage at the output of the chopper transformer | Ver a r811 de 820k - 1/2w. | ||
VESTEL |
7299 TS
|
Power supply with lack of power. | Your breastfeeding/or | ||
VESTEL |
11AK19-8A
|
Does not start using the command, nor by pressing the p+ key | The following case may occur: the infrared receiver is faulty and the keyboard is locked (children locked) | ||
VESTEL |
11AK06A-4
|
Mute, vertical (h dash), tuning off | R828=15k open |