Vestel Repair Tips
Search: vestel
Results: 169
Results: 169
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| VESTEL |
11AK19
11AK19 |
No e/w correction | R629 burned. normally caused by a change in l602 1mhy (3002026). also check the c630 .43uf | jose luis calcada | |
| VESTEL |
11AK19
11AK19-E3 |
Does not power on. red LED turns off | 8v regulator, has 4v | Replace 47μF/250v capacitor in secondary | jose luis calcada |
| VESTEL |
11AK08
|
Out of phase | D802 with leak | ||
| WATSON - VESTEL |
WATSON FA6339
|
Does not start - front LED flashes quickly at half brightness | Replace r867 which was over 30kΩ | ||
| VESTEL |
CH 11AK19
|
Subst ic tda 8840 1y >> 2y | In service mode, correct the setting "04" if-pll, example 62 >> 75, also "03" agc, 28 >> 20 | ||
| VESTEL |
7298NT CHASSIS 11AK12-9
|
The image gradually shrinks horizontally until it is just in the middle of the screen | Change 10m r441 with changed value on the 33v line | ||
| VESTEL |
7296 CHASSI 11AK12-6
|
Vertical with lack of amplitude | R441 of 10m changed even with approximate value (replace it) | ||
| VESTEL |
CHASSIS 11AK19 C/ MC44604P
|
"grila" em st by ... | R816 (1.5 mΩ) open | ||
| VESTEL |
7299ST CHASSIS 11AK16-2
|
E/w issues and rgb lines at the top of the screen. | Replacement of the tda8376 ic to repair the e/w and r714 for the lines problem. | ||
| VESTEL |
CHASSIS 11AK19E3
|
LED flashes weak green. low voltages and pulsating (+b 40v) | R867 0r33, d871 zpd12v | ||
| VESTEL |
11AK19E3
|
High power supply around 180v, not adjustable with the potentiometer. | Replace broken r823 | ||
| VESTEL |
VARIOS
|
In models where there is a spike on the lid that will touch the tranf. lines next to the mat outlet, in dusty and humid conditions it causes serious leaks | As a preventive measure, cut the spike | ||
| VESTEL |
5166 - 11AK10-15
|
Power supply tr q801 burnt out, burns again as soon as the switch is turned on. | R805 open. | ||
| VESTEL |
CHASSIS 11AK19E3
|
Does not work, there is no voltage at the output of the chopper transformer | See r811 de 820k - 1/2w. | ||
| VESTEL |
7299 TS
|
Power supply with lack of power. | Your breastfeeding/or | ||
| VESTEL |
11AK19-8A
|
Does not start using the command, nor by pressing the p+ key | The following case may occur: the infrared receiver is faulty and the keyboard is locked (children locked) | ||
| VESTEL |
11AK06A-4
|
Mute, vertical (h dash), tuning off | R828=15k open | ||
| VESTEL |
3731T CHASSIS 11AK20M-3
|
A few seconds after switching on you hear the noise of a boat engine and 3 or 4 feedback lines appear at the top of the screen | Change the line transformer | ||
| VESTEL |
11AK19E3
|
No image. with sound. When speeding up the screen, there would be return lines from the middle of the screen to the top | Change c433, c434, on pins 46 and 47 of ic401 | ||
| VESTEL |
11AK19E3
|
Low voltages and pulsating (+b with 40v) | R867 amended |