Repair Tips
Search:
Results: 87721
Results: 87721
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDV8AFU
|
No chroma | In camera mode - no chroma in video out, but luminance ok. | ||
| SONY |
KV2781R
|
No pincushion, replace r-536 on "d" board | Picture bowed in at sides (pincushioning). | ||
| SONY |
SLHFR30
|
No drum lock in betascan | Pb and rec ok, but no drum lock in betascan. excessiveripple on 12v regulated dc line. | ||
| SONY |
KV1961
|
Intermittent brightness fluctuations, leakky c307 | Intermittent brightness fluctuations. pin 4 of ic301 read1.5v instead of 5.5v as shown in manual. | ||
| SONY |
SLHF500
|
Drum ass'y parts change | Original p/n is subbed to a-6050-340-a. connector has roundholes and will not fit into cn1 on the rp-16 board. -hq comments: kcp checked stock and found a few incorrect parts in bin.incorrect type is a-6050-139-a (dsh-21ar, round hole connector). corr | ||
| SONY |
CCDV110
|
Viewfinder charactors | Viewfinder will only tell date, time, main and sub titles.everything functions properly. just missing charactor information. | ||
| SONY |
D3
|
Intermittent skipping on beginning of disc | According to servicer, unit intermittently skips. alladjustments checked ok. -hq comments: usually, skipping at the beginning or end of the discindicates poor mechanical alignment of the sled drive mechanism. checkcarefully for binding. | ||
| SONY |
KV2780R
|
Intermittent high pitched squealing, glue coils on yoke | Intermittent high pitched squealing. | ||
| SONY |
XR510R
|
Control functions do not operate correctly | Prior to replacing ic701 there was: very intermittent autoseek, no manual scan, no display change from radio to time, no direct add-ress of presets, no memory preset, no memory scan and no band change. nowthere is no automatic or manual tuner functions. | ||
| SONY |
XR33
|
No audio during tape playback | No cassette pb. radio volume normal - no audio on tape. | ||
| SONY |
CCDV110
|
Int. loss of picture sync | This unit would int. loose the picture sync. this was causedby the crystal changing frequency. | ||
| SONY |
SLHF450
|
Shuttle ass'y | On playback there was video noise. the noise was about 5 to 8lines, random through the screen. looked like shot noise, 2 to 5 of themhorizontally across the screen each being 5 to 8 lines in width. replacedshuttle ass'y, could see nothing wrong with d | ||
| SONY |
KV2782R
|
Shuts down, replace damper d-516 | When unit is turned on, it will shut down immediately.troubleshoot set using low voltage. found horizontal output distorted.traced problem to a shorted damper diode. | ||
| SONY |
CFSD7
|
Part number for control board | Looking for a part number for the control board (w/parts) ifthere is one available. -hq comments: mounted control pcb is no longer available. we can geta blank control pcb from rpc in tokyo if you want one. let us know. | ||
| SONY |
SL5200
|
Beta hi-fi light won't turn-on in hi-fi playback | Unit received from authorized servicer. found several patterncuts and jumpers on fs-27 board (1-609-754-11). has there been anychanges? -hq comments: checked board in lab and found it does not agree withschematic or board layout. block diagram is ok. | ||
| SONY |
CCDV110
|
After 10 minutes picture distorts - camera only | After 10 or 15 minutes picture would loose color and turn tohoriz. streaking lines on camera only. | ||
| SONY |
HVL80D
|
Need p/n for rear housing | Need p/n for rear housing, below ref. no. 6, pg 18 of s/m. -hq comments: this part is unavailable, however i sent one piece fromour lab to jim rosemary in itasca, ill. | ||
| SONY |
KV20XBR
|
Can't turn unit on | Set could not be turned on with manual button, but you couldturn it off. when turned on with remote, rgb and video leds were lit.by turning these modes off with manual button the set would then functionwith tv air signal ok, plus all remote functions in | ||
| SONY |
D10
|
Will not track inside of disc | Unit will not track inner most part of disc. pushed downoptical block and unit started tracking. suspected defective upz orimproper upz height adjustment. if upz spacer is available, let us know. -hq comments: the spacer is only available with the op | ||
| SONY |
TV5000
|
Ac/dc power plug | Above p/n shows 2 halves (or sections) bolted together. partreceived from npc is only front section that wires solder to back section,which mounts to chassis is missing. does this section come mounted withchassis? -hq comments: the half of part which |