Repair Tips

Search:
Results: 87727

Make	Model	Symptom	Problem
SONY	CDP45	Intermittent mistracking	Rf waveform was ok except p-p voltage was 2.0v. checkedwaveform from ic201. gain down sw seemed to be on most of time.control signal to switch from ic202 pin 7 was high most of time. flexingckt board caused dc level to drop.
SONY	CCDM8U	Service manual	I do not find an electrical parts list in the manual orsupplements for the above board. -hq comments: because it is so difficult to troubleshoot the mx-2 boarddoes not have a parts listing but is offered as a replacement part p128service manual.
SONY	SLHFT7	Intermittent no beta hifi pb	Intermittent no beta hi-fi. flexing board would causeproblem to come and go. could not troubleshoot to component level.
SONY	CCDV110	Bad playback	Poor playback picture.
SONY	CCDV110	Dead - tape stuck	Found not power up unit.
SONY	SLHFT7	Lines in picture on some channels	Lines in picture on some channels.
SONY	SL100	No functions, tape stuck	No functions, pause light on all the time, with power on capsand drum both running.
SONY	CCDV1	No led display	No led display.
SONY	CCDV110	No rf picture	Picture in viewfinder was good but no picture using rfadaptor.
SONY	APM007AV	Need part number	Need part number of switch board on page 2. -hq comments: the amp board includes the sw board. please order1-613-776-00 from kcp.
SONY	D7	Optical pick-up replacement	After replacing optical ass'y, unit not functional or veryintermittent.
SONY	KV2680R	Intermittent and weak color, replace ic-201	At first, the color appeared slightly weak when compared withanother color tv. gradually, over a period of several weeks, the colorwould come and go like it was having trouble locking on to the station.
SONY	WMF50	Battery lid part number missing	Battery lid part number not listed in service manual. wasadvised by tech. dept. that the part number for the battery lid isx-3330-416-1.
SONY	HMK3030	Pinch roller part number wrong	The part number for the pinch roller in the hmk-3030 is wrong.when you order the pinch roller part number, you get the mechanicalchassis. in the manual, the mechanical chassis and pinch roller are thesame part number (x-3573-102-0), and this part number
SONY	CCDV8AFU	No auto focus	No auto focus because of open infra-red emitter diode.
SONY	CCDV8AFU	Hairline cracks in plastic near screw holes	Hairline cracks in plastic near screw holes. these cracksoccur immediately upon installation of handle to base.
SONY	SLHF900	Head clogging	When using high grade tape heads clog in just a matter ofhours following cleaning. three samples: this machine and two others,all are original filled heads.
SONY	KV2782R	Set lock on one channel, reinstall front panel	Set was locked to one channel and aux was being displayed.found aux/ant switch closed. by removing the control panel, problemdisappeared. this is the third set. i have seen with this problem andby only removing the control panel, the problem cures its
SONY	TT2005	Correct part # for tt-1 pcb	Part # in s/m is nowhere to be found on fische or in computer. -hq comments: the part number (a-6721-101-b) is now in the system.please order it through kcp so that they may order from tokyo. deliveryshould take about 2 weeks.
SONY	KV1370	Missing ref number	Supplement #1 r255 designation omitted from schematic.voltages around q251, q252 missing. similar situation with kv-1325,kv-1326, kv-1365, kv-1367 and kv-1396. -hq comments: we will inform tokyo of the omission of the resistor ref.number.