Repair Tips

Search:
Results: 87727

Make	Model	Symptom	Problem
SONY	PSLX520	Incorrect part number	Incorrect p/n : a-4630-148-0 correct p/n : x-4887-404-0 -hq comments: we have issued a s/b.
SONY	SL250	Terminal 1 and 3 on rd-22 board correction	When you order pc101 p/n 8-719-939-28, you get spi 214 acwhich does work in circuit. now the board itself (rd-22) when wired thesame way as the schematic. -hq comments: the schematic diagram of rd-22 board is wrong. the boardterminal numbers 1 and 3 s
SONY	KV2775R	Dead, replace fbt, h out, regulator and fuse	Dead.
SONY	CDP55	Erratic operation	Erratic operation.
SONY	SLHFT7	Pix jumps	Playback picture jumps.
SONY	STRAV580	No am operation	No am. found r242 leg shorted to power supply trace. base ofq204 (am/fm switch) held at wrong potential not allowing switch tooperate.
SONY	CCDV1	No remote	Remote does not work. ic303 not outputting at pin 20.
SONY	CCDV110	Vert roll in viewfinder intermittent	Intermittent roll in viewfinder.
SONY	CCDV110	Intermittent loss of picture	After 2-3 hours unit would loose video. found to be tapsensitive. always ok when cold.
SONY	EVS700U	Won	Drum was stuck, could free drum but would stick again. drumalso noisy.
SONY	CCDV8AFU	Intermittent no pix in viewfinder	Intermittently no picture on viewfinder when camera poweredup. this would only occur at power up cold and would clear after a fewmins. would not occur again all day. found complete loss of 28 mhz osc.play back picture fine.
SONY	EVS700U	Noise specks in play	Noise specks in play, noise bar in slow determining ch. 1 headoutput weak. most apparent in lp mode.
SONY	EVA300U	Erratic video	Unit had erratic video. found problem to be bad heads.
SONY	CCDV8AFU	Pix tears	Picture tears and breaks up.
SONY	HVL80D	Missing part number	Need p/n for shaft located in front of ref #20 on page 18. -hq comments: p/n is 2-398-010-01.
SONY	EVS700U	Shimmer in picture	Picture appears to shimmer or quake horizontally on p.b.prerecorded tapes look better than those recorded on the machine. this isa very subtle shimmer but is aggravating to watch for more than a fewminutes.
SONY	SL8200	Part number needed	Do we have part number for 1) lever compression 2) lever3) ass -hq comments: sorry, but due to age of the unit, these parts are nolonger available.
SONY	KV25XBR	Vertical foldover at top of screen	Vertical foldover at top of screen with overscan. foundslight distortion in waveform at dy-3 pin 1. all voltages normal with theexception of collector of q1507 being 40v instead of 62.4v as received.
SONY	KV2643	Very low brightness, replaced r2217	Sub brightness set to max and still not enough lum level.installed two cx556 (ic301) on a board and still no 1.5v on pin 26, 27,28. voltages read about 0.4vdc but the ac component was present.
SONY	CPD1302	Slight bend in vertical lines	Very slight bend in vertical lines at top one inch of screen.i was suggested that i try to modify afc circuit to resolve complaint.