Repair Tips
Search:
Results: 87727
Results: 87727
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
CDP302II
|
Bu-1 - fractured plastic mounts | All bu-1 blocks received are received in sealed boxes, butwhen the boxes are opened for installation of the part, it is discoveredthat two or more of the plastic legs are broken. also, some bu-1suffer severe main chassis fractures. i have been using bu | ||
SONY |
CCDV110
|
No rf output | No rf out of rfu80 connector to tv. video and audio outputare functioning. no b+ to rf connector present. | ||
SONY |
CCDV110
|
Dead set | Unit came in dead. replace f381 connect all cables andharnesses. unit comes on but no camera video. playback deck works fine. | ||
SONY |
CCDV8
|
Red line appears | Red line appearing from middle left side to center of screen.verified that it was a camera problem. appeared during e-e and playbackviewing. | ||
SONY |
SLHF550
|
Vertical jitter and rolling on copy guarded tapes | Vertical jumping and jitter when playing back prerecordedtape. -hq comments: problem is that copy guard changes the duty cycle of thetiming pulses in the vertical interval. certain tvs and monitors are moreaffected than others. older sets are more tol | ||
SONY |
EVS700U
|
W2n | Tried adj. 5-2-3 (tracking adj.) on pg 241 but had no effecton pix quality. also could not obtain waveform as shown. -hq comments: the tracking adjustment affects the dc bias of the 16khzand 46khz signals derived from the four atf pilots. adjust for m | ||
SONY |
KPR4110
|
Erratic operation at turn on,replaced power supply | Turn set on and rgb, video #3, sap, aux ??? comes on with nosound or picture, will turn on by remote but not manually. | ||
SONY |
TCW3
|
Muting problem | Unit was muted on both decks. however, with deck a in playmode, pushing deck b play, ff or rwd buttons, unmuted deck a. pin 42 ofic303 was low. d317 is not in the circuit nor is the foil pattern whereit is shown. | ||
SONY |
ICF2001D
|
No tuning fuctions, display goes to 150khz | Unit will not tune. display will get stuck at 150 khz. foundcracked c118 on pll. | ||
SONY |
SL2710
|
No tuner mode | Unit would not operate in tuner mode. channel indicator ledwould not light up and no picture on monitor. | ||
SONY |
SLHF1000
|
Pix distorted during self rec pb of computer signal | When recording off an apple iie computer, during playbackthe unit exhibits severe horizontal tearing. i contacted apple and foundthe iie operates at 15,700hz horiz/non-interlaced, and 59.92hz verticalfor the composite output. -hq comments: i checked th | ||
SONY |
KV1961
|
High pitch hum (int), jumper wire vibrating | Intermittent high pitch hum, loud at times coming fromlocation of flyback. | ||
SONY |
KV2771R
|
Audio popping, replace c-140 on "a" board | This unit had intermittent popping in the audio. | ||
SONY |
CCDV8AFU
|
Ps601 blows | Blows fuse ps601 on mc-4 board after 4 hours operation withac-v8uc ac pack. applying logic analyzer to e and b of regulator q619received a positive pulse on both elements when the fuse blew. | ||
SONY |
CDPC10
|
Low level hum | Unit puts out a low level hum, easily heard in play pause withvolume turned up high. | ||
SONY |
SPP100
|
Noise heard on handset | Customer complained he heard noise coming through handset.by disconnecting c416, it was determined that the base unit was transmit-ting a noisy signal. | ||
SONY |
XR27R
|
Radio intermittently shuts off by itself | Bad solder connection on d525. the hole is too large for thelead size. the solder does not make total contact around the hole and thelead. | ||
SONY |
SL2700
|
Brake solenoid would not engage | Brake solenoid would not engage, brake solenoid opened.found problem to be a leaky switch (q332) causing forward bias on q309. | ||
SONY |
CCDV8AFU
|
Scrambled pix | Intermittent scrambled pix. could hear rattling in unitwhen moved. | ||
SONY |
CCDV8AFU
|
No video rf | No video out on vhf-rf. |