Repair Tips

Search:
Results: 87727

Make	Model	Symptom	Problem
SONY	CCDV8AFU	Eject led and noisy motor	When using ac adaptor, eject led flashes. motor noisy onbattery operation.
SONY	CCDV8AFU	No record	Flashing eject led, will not stay in record mode.
SONY	CCDV8AFU	Bad pix	Pix fuzzy on playback. eats tapes.
SONY	CCDM8U	Bad playback	Bad playback. tape jamming.
SONY	CCDM8U	Dark playback	Playback from recording darker than pre-record.
SONY	BMC220	Playback video	No video during playback mode.
SONY	CCDV8AFU	Distorted pix	Picture distorted.
SONY	CCDV8AFU	No viewfinder function	No playback thru viewfinder.
SONY	TAAX520	Volume display did not indicate correctly	The audio level leds would not rise and fall with equallinearity. by applying an external dc control voltage to the led driver,they would work ok.
SONY	KV25XBR	High pitched squeal	Customer complained of high pitched squeal. he also told methat he hears the same noise from several xbr units and also competitionmodels also. i told him i would see what i could do to alleviate theproblem. using my sniffer, a hose with a small trans
SONY	KV20XBR	Only sleep lite and rgb leds were lit	When set turned on, only sleep lite and rgb ledwe found horizontal output transistor was shorted.
SONY	CCDM8U	No drum servo lock - unit shuts down	Unit shuts down after 1 or 2 sec. operation. found ref v,pin 7 sv-16 board not locked. traced problem to x681 vc-4 board.
SONY	CCDV110	Title and subtitle don	Title and subtitle work but will not hold in memory.
SONY	CCDV110	Doa	Unit came in doa.
SONY	KV25XBR	Excessive hv	The unit would go into hv shut down. we found after defeatingthe shut down circuit that the b+ was normal but that the hv was 35kv withno beam current/32kv max beam. we traced the problem to a defective c1664on the d board. this is the main tuning cap
SONY	KV2780R	Color too bright, replace jungle ic-301 on "a' board	Color intensity too high.
SONY	KV2680R	Power up only, c-140 shorted	Set would power up from the front panel. couldnoff. no functions worked. sleep light did not light. memory chip andpll controller had been changed by asc.
SONY	KV1357R	Cannot program tuning, replaced ic-201	You could go through and turn channel set on and program allstations and everything appeared to work normally. but when you turnedchannel set switch off, set would scan thru stations until vc on tunerreached max vc. memory chip ic-002 and pll controlle
SONY	KV2681R	Set lock up at turn on, replace r-611 on a board	Set would turn on and off at power switch only. no otherfunction would work. on the x board the only problem that we could findwas no clock on vip chip ic031. chip and crystal had been replaced.
SONY	KV2782R	Pop in sound on bright to dark pix transitions, c-672	Sound pops on scenes such as star war type laser blasts &quick flash backs. 18v power supply rises from 18-23v (dark to bright)and decays rapidly with a spike preceeding decay (bright to dark).