Repair Tips
Search:
Results: 87722
Results: 87722
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SL2710
|
W&f and poor capstan lockup | Capstan wow and flutter, with transition from cue and pause toplay not smooth. capstan would speed up and slow down several timesbefore locking. on sl-2710 #11456 it was noticed that c29 and r110 wereremoved from the ss-19 bd. sometime after production | ||
| SONY |
CCDV8
|
S/m correction (q716, cp9 board) | Wrong p/n in s/m, page 159. 8-729-122-23 is incorrect.8-729-122-63 is correct. -hq comments: the ccd-v8afu s/m (page 162) incorrectly lists q716 as8-729-126-23. as with the ccd-v8, the correct p/n is 8-729-122-63. wewill issue a s/b shortly. | ||
| SONY |
WMF15
|
No audio output | No audio output. measured dc voltage at pin 13 ic303 was 0.8vinstead 2.95v. found q302 defective (open base and emitter). | ||
| SONY |
D7S
|
No play | Unit will not play. found fop would slide along shafts.opening bottom cover found above part broken. sample is being forwardedfor your inspection. | ||
| SONY |
CDX5
|
Broken door | Found ref. no. 232 missing and ref. no. 227 (pg 49 right doorretainer) inside machine. door retainer was loose and jamming loadingoperation. | ||
| SONY |
STRAV560
|
Poor am/fm sensitivity | Unit had poor sensitivity on both am and fm. cpu would lock upon some of the functions. | ||
| SONY |
D5
|
Sled does not return | When stop button is pressed power turns off, but sled does notreturn to its rest position. | ||
| SONY |
CFS55
|
Missing part numbers | Missing part numbers. -hq comments: part numbers are as follows: lever, fwd button 3-561-837-00 lever, stop button 3-561-838-00 lever, rew button 3-561-856-00 lever, pause bu | ||
| SONY |
FD2A
|
Poor focus, broken land on d2 board | Unit has no focus and adj. has no effect. found broken landon d2 board. hole for adj. of rv803 seems to be drilled out so much thatit is cutting off the foil pattern i have checked out. fsc report seeingseveral with same problem. | ||
| SONY |
XR33
|
Part # for rubber connector | Car stereo dist needs this part fisch and kc says it isnot available. what is available to use? -hq comments: part number for ref. #54 is 3-326-010-01. we will issuea s/b. | ||
| SONY |
KV2670R
|
System control lock-up, replace x-101 ceramic osc | Tv has hv with ear next to speaker. there is noise fromspeaker. but there is no brightness and using the power switch on frontof tv or remote hand unit the tv cannot be turned off, clock at pin 1ic103 less than half the amplitude given on the circuit d | ||
| SONY |
KV2670R
|
System control lock-up, perform procedure for no vip | Tv has hv and with ear next to the speaker there is noisefrom the speaker. but there is no brightness and using the power switchon the front of tv or remote hand unit the tv can not be turned off. | ||
| SONY |
STJX205
|
Am tuning interval st-jx205/jx520 | St-jx205 is in the 9khz am tuning mode. no procedure in thes/m for changing the am tuning mode to 10khz. | ||
| SONY |
BMC220
|
Right half part of picture is green | On pb and e-e (with jig), right half of screen appears green.left half okay. disconnecting chroma on jig gives good b&w picture.found 8-pin socket for the saticon tube was damaged electrically. wig-gling socket caused problem to appear and disappear. | ||
| SONY |
KV2783R
|
(s) in sound, adj rv-830 on "x" board | Customer complained about (s) in sound. | ||
| SONY |
CCDM8U
|
Tape transport jammed (no mechanical movement) | Tape transport sec jammed unit totally inoperative. dis-assembled entire transport sec to find gear b damaged teeth sheared off.plastic gear meshed with metal gears. ls chassis had to be removed whenchassis was not in ready mode due to the damaged gear | ||
| SONY |
SL2710
|
No stop in pause | No stop in pause. the capstan would contain to pull tape try-ing to get a clear picture in pause. the tape pulled would still on exitside because the reels do not take up tape in pause. these units hadmany hours on them and there were wear marks on up | ||
| SONY |
SLHF900
|
Int loss of rf from head amp | This unit would int lose rf output from ic001 pin 27 and 16.ic001 would switch to the record mode of operation, because pin 13 was at4.5v. ic407 v-rec p output was int wrong. | ||
| SONY |
CCDV8
|
S/m correction (vi-6 board) | S/m error. page 110 location f-15. junction point missingfrom node of c140, r140, r145 and r146. this node is in the main videosignal path and should be correctly marked. -hq comments: this node is the point where pb/ee video is divided into2 paths. | ||
| SONY |
HVR200
|
Missing part number (gear) | I need part number for gear located by 57 on page 17. -hq comments: please refer to s/b #237 (feb 7, 1986). p/n requested isx-2394-407-1 (shaft 7 ass |