Repair Tips
Search:
Results: 87721
Results: 87721
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
WMF75
|
Part number missing | Page 5 of s/m sony bond sc-108, no. 9 digit part number given. | ||
SONY |
SLHF600
|
Video noise | Units displayed white video noise, resembling static, duringplayback. | ||
SONY |
KV3000R
|
Dead unit | Dead. f604 was opened. | ||
SONY |
KV2680R
|
Sound fm r speaker is much louder than l sp, resolder c-1190 | Sound from right speaker is much louder than left speaker. | ||
SONY |
KV20XBR
|
Dead unit | Dead. f601 was opened. | ||
SONY |
KV3000R
|
Unit was dead | Dead. f601 was opened. | ||
SONY |
D7
|
Distortion in headphone | Only headphones are distorted (intermittent). | ||
SONY |
BMC550
|
No auto focus | Unit came in with complaint of no auto focus. after extensiveelectronic troubleshooting and adjustments i noticed that the push rodthat is activated by the lens barrel to give mechanical reference to theinfrared transmitter did not move when lens moved. | ||
SONY |
SL9090
|
No unloading or loading | Unit came in with cassette stuck inside. manually removedtape, but unit would not load or unload. | ||
SONY |
SL10
|
Will not load, drum spins very slowly | Ic201 was blown. replaced ic201, loading was very slow, thenjammed. found solder between teeth on gear (d) (ref 269, p98). removedsolder and reassembled. loading action was restored, but drum motor ranvery slow in play, and would run slowly even in s | ||
SONY |
FD2A
|
No brightness or raster, resolder c board pad "a" | No brightness or raster on crt-high voltage, filament, video &other signals to crt check ok. | ||
SONY |
BMC550
|
Poor pause edit (gap between recordings) | When operating record pause the recorded video has a long gapbetween the recordings. the gap at this edit point is long enough attimes for the video that was previously on the tape to be seen when thetape is played back. found that the reel brakes were | ||
SONY |
WMF10II
|
S/m correction | Page 29, ref. 9 and 10 reversed. -hq comments: we will issue a s/b. | ||
SONY |
EVS700U
|
Noisy picture when unit is hot | When unit is hot, unit records & plays back noisy recordings.rf envelope ok, compared to good unit. when unit is cold picture appearsok. when drum/motor ass'y is heated externally the picture deteriorates.this is the second unit to have this problem sh | ||
SONY |
D5
|
Unable to read tco | The fop after playing a disc does not return to the startingposition, and when you press play the fop still does not come to the innerposition. | ||
SONY |
SSU460
|
Change in replacement woofer | Original speaker is a 1-503-139-11, using a cosmetic skirtaround woofer. replacement speaker has no skirt, and is a 1-503-139-12. | ||
SONY |
CDP70
|
Intermittent door operation | The door would intermittently open and then close again.we found the loading switch s703 to be dirty and causing the problem. | ||
SONY |
TCFX510R
|
Intermittent operation | Eats tapes, no rew or ff. unit had been to ssc two times with no problem found. servicer found ic601 to be intermittent. | ||
SONY |
KP5020
|
Vert jitter on scrambled channels | Problem is intermittent every 10-30 sec. cust. used viacomcable box. signal strength measured 1000uv for cable and air signals.12db attenuation stopped jitter but pix was snowy. waveform check at tp12shows sync pulse distorted. | ||
SONY |
ESR5
|
Periodic static pop in tape mode when warm | Unit would produce a static pop in tape mode through speakersapprox. every 20 sec. noise was moderately loud and did not vary withvolume control setting. eliminated problem by grounding shaft of gear(item 273 on pg 27 of s/m) which drained the static c |