Repair Tips
Search:
Results: 87717
Results: 87717
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV2681R
|
Dead, resolder t-501g | Dead. set does not turn on at all. no signal at base ofhoriz. out. q504. however, there is signal at q503 collector. | ||
SONY |
KV1913
|
Shut down | Customer had unit into fsc four times for regulator failure.found hvr assy cracked. set has been operating for three months withoutfurther failure of regulator. | ||
SONY |
CCDV8
|
No drum rotation | No drum rotation. signals reaching drum drive ic. | ||
SONY |
CCDV8
|
Power on/off ok, all other functions inoperative | 1) power on, drum rotates for approx. 10 sec, then eject ledblinks. all buttons inoperable. 2) capstan motor would not rotate, unitwould only thread/unthread. this occurred after repair 1) was performed. | ||
SONY |
CCDV8
|
Rewind button inoperative | 1) rewind and review inoperative using rew button (p/b ok).after cue (ff button) is released, unit automatically enters review mode.2) p/b picture noisy. | ||
SONY |
CCDV8
|
Tape jammed intermittently | Motor intermittently won't start unless rotated manually. | ||
SONY |
CCDV8
|
Playback jitter and noise | Cleaned, no help. | ||
SONY |
CCDV8
|
Pins bent on 24 pin connector | Pins 23 and 24 were bent. -hq comments: pins 23 and 24 are not used on the multipin connector.the recommended solution if pins 23 and 24 are bent is to cut them off atthe base. | ||
SONY |
CCDV8
|
Intermittent no function | Osc change frequency. | ||
SONY |
CCDV8
|
No eject | Frozen motor. | ||
SONY |
XR66
|
Non manual autoreverse | Unit will auto reverse at the end of the tape but not whenthe front panel buttons are pushed. | ||
SONY |
CCDV8
|
Playback picture unstable after 1 - 2 hours | After approx. 1 to 2 hours of operation drum and capstanservos would become erratic. picture would jump from side to side andtracking noise would appear. also, capstan would not run at all. inter-mittent capstan (from play or rec mode) would cause shu | ||
SONY |
SL2500
|
Rewind problem | Close inspection of enclosed upper drum revealed a slightimperfection (marked). replaced again ok.-hq comments: we will evaluate this sample and inform you of our results. | ||
SONY |
D5
|
Static after 10 to 30 mins | Unit has static after warm-up. | ||
SONY |
CCDV8
|
No eject | Unit came in with tape jammed inside. i found that the unitwould not unthread, it would play fastforward and rewind. | ||
SONY |
CCDV8
|
Shut down after 5 seconds | This particular unit was going into shutdown. after 5 secondsof play, the unit performed all function for that 5 seconds. the onlytime the unit worked without shutting down was on still. | ||
SONY |
BMC550
|
Noise in audio on quiet scenes | Customer complains about background noise from auto focus andmechanism. cs-5 board changed. -hq comments: due to the proximity of the microphone to the focus andzoom motors, acertain amount of noise is unavoidable during quiet scenes.reducing the gain | ||
SONY |
CDP102
|
Wrong motor coil wiring | Motor coil wiring is wrong for l152-2 on hook up/board layoutpages. this coil is shown connected out of phase. copy of page 40/41 ofcdp-102 manual attached. note corrected copy. -hq comments: confirmed the wiring of l152-2 should be crossed as youfou | ||
SONY |
SL2700
|
Cross talk | This unit had bad cross talk on both channels. the outputsfrom the band pass filters was not clean. bpf-801/802/901/902 wereall bad. | ||
SONY |
CDP200
|
Drawer will not open | The drawer would not open because the chucking motor (m802)gear penetration was too tight. |