Repair Tips

Search:
Results: 87717

Make	Model	Symptom	Problem
SONY	STRVX5	Part number for ribbon cable	Would like a part # for ribbon cable (3-wire) for the q801mod. mentioned in s/b #141r. also a longer screw is needed for mountingq801 on the heat sink. a part # for this would also be handy. i noticedit is not mentioned in s/b #141r but q801 must be i
SONY	SLHF900	Audio muted	Audio was muted for all functions.
SONY	SL25	Excessive drum speed, picture distorted	Drum speed excessive. there was approx. +10vdc on drum errorline which should be about +6vdc. drum free speed control had no effect.checked drum pgs and found pgs pulse missing, checked pg coil and foundit open.
SONY	XR40	No part number for flex connector	Part number for flexible connector which connects the powerboard to the display board is not given in the service manual.
SONY	SL2300	Servo will not lock up	Both units, servo will not lock up. on the ss-25 board theconnections at r12 and r17 were carbonized. removed the old solder.
SONY	D5	Sled limit switch malfunction	Unit would not play discs. when play was pushed, the fopwould move outward a fraction of an inch and stop. measuring resistancebetween the gray lead from s903 and metal parts of the sled motor assy,we were reading approx. 400Ω.
SONY	RS30	No ogm recording	The unit did not record ogm and the 1khz beep was always on.
SONY	CDP200	Top jumps all over the disc	After one hour of playing, the unit started skipping and thetop jumped all over the disc and finally went to the outside.observed the tracking error waveform. it was jumping like crazy.
SONY	CDP101	Focus coil oscillates	After one hour of playing, the unit started to skip the discand rejected it. the objective lens was making the cracking noise.
SONY	TC152SD	No ff/rew	The unit did not rewind or fast-forward.
SONY	CDP111	Noise in audio	There was noise in audio. it sounded like there are a lot ofdropouts on the disc.
SONY	ICF4910	Sw does not stay on	Am and fm work fine, but the sw mode does not stay on. whenpressing the sw button, the function seems to switch to sw but it doesnot stay in sw.
SONY	KV25XBR	Missing part #	Please obtain part number for chassis plastic frame andshield sections. -hq comments: the part numbers you need are as follows:ac supply case (main) 4-374-138-02ac supply case (top) 4-374-133-01ac supply case (bottom) 4-374-134
SONY	CDX5	No part number - roller pin	Pin dropped out. -hq comments: the part number is a-3239-289-a. the roller assy includesit. we have already issued a s/b (car stereo #47).
SONY	KV2657R	No pix	Same dealer had 3 sets out of box with no raster. sets hadsound and h.v. they found a crack on all 3 boards in the same spot.
SONY	TCD5-M	Stock defective plain bearing assy	Servicer reported and showed me 3 plain bearing assy he hadreceived from kc that were defective. when put in tc-d5 unit would runfast. in each case he found fine wire broken. states that he never hadthis problem with others until kc started loose pack
SONY	STRAV560	No audio output	No sound output. display and all tuning functions workedwithout error. audio signal was at the input of ic602 asp chip but nosignal was being switched out. found pin 21 clock signal being held at4.8vdc. traced this voltage back to main board to q221.
SONY	KV1943R	Blanking - vert problems, replaced c529	Set was stretched on bottom three inches of screen. the topfour inches were fine but there was a black vertical bar that was aboutone inch wide on the left and widened to three inches on the right side.it was blacked out in this one area only. adjustin
SONY	MLV1100	Service manual correction	No audio output. i found out that the s/m and the unit aretotally different. for example, on the s/m audio output ic has 14 pinsbut looking at it i can have only 12 pins.
SONY	STRVX4	Missing part number - c803	I need the part numbers for the filter caps designated c803,c804 in the service manual. see page 35 section q4. they filter thebridge diodes output. i have a unit s/n 860295 which had both capacitorsexhibit leakage on the main power board. sample inc