Aiwa Repair Tips
Search: aiwa
Results: 315
Results: 315
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| AIWA |
NSX-F12
|
5 cd carousel, motor does not have the strength to turn the carousel | 33Ω r changed CD board feeds q401 to 406 | Bruske | |
| AIWA |
NSX-999
0118 |
Panel lights up weak | Electrolytic c108 c107 | Solved | EDSON |
| AIWA |
NSX-S22
|
Nothing appears on the display | Open 27k resistor r116 is at the power supply | ||
| AIWA |
AR295
|
Power supply a little higher than normal and ticking on the power supply relay. does not generate high voltage. | 127k r820 open | Replace r820 | Edson S.A. |
| AIWA |
CX-81MH
|
Display does not light up | Check c107 and c108 of 22uf | MATA | |
| AIWA |
CX-81MH
|
Display does not light | C107 and c108 of 22uf dry | MATA | |
| AIWA |
NSX-S22
|
Don't read the CD for two rounds, play the laiser but don't read | Change the plate under the table and check the flats | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA |
NSX-S22
|
C dl | Optical unit | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
| AIWA |
NSX-S22
|
There is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Optical unit | ELETRONICA ARNI-LEOBERTO LEAL /SC | |
| AIWA |
NSX-S22
|
There is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Optical unit | ELETRONICA ARNI-LEOBERTO LEAL /SC | |
| AIWA |
NSX-S22
|
There is no sound on the CD, just a low noise, and on the radio, aux and normal deck | Change the plate under the table and check the flats | ELETRONICA ARNI-LEOBERTO LEAL /SC | |
| AIWA |
F15
|
Turns off by itself even without the box | Small pieces of wire break inside the box connector | Remove the connector and remove them, there are some that get stuck with the shorts | wendel |
| AIWA |
CX-NS505 - NSX-S505
|
The display lights up normally, after a few minutes it starts to flash slowly and increases until it goes out and some characters randomly light up. | Q102 (rn1410) | I removed the transistor, as I didn't have another one to replace it, I left it without it, and the device is working perfectly, without any problems. All device functions are working. | Aderbal |
| AIWA |
NSX- S74
|
Hoarse sound | Pr201 open | Adrian Chapadão | |
| AIWA |
NSX- S74
|
Turns on and off at the same time | Cap 3300yf/75v da power supply e q219 | Replace | Adrian Chapadão |
| AIWA |
NSX-S22
|
Turns on turns off only stays on standby when turned on turns off immediately | Pr 201 was just changing and running for the hug | CARLOS AUGUSTO ELETROSILVA CANAVIEIRAS BAHIA | |
| AIWA |
TV-AR295RH
|
RGB defects and only displays video when enlarging the screen | R904, r910, r916 (100k) | Check r904, r910, r916 (all 100k) | MACCELETRONICA |
| AIWA |
Z-R900
|
Opt unit mechanics. inoperative and the tray does not rotate | Skip doesn't work and doesn't search for cds | Replace a 33hs\1w resistor on the board under the tray, position the optc unit in play with the larger pulley out, then just put the pulley in place and hug | ffeet |
| AIWA |
NSX-F958
|
When turning on the box turns off immediately | R-268 open | ||
| AIWA |
TV-AR295 RH
|
Didn't care | Saida horizontal bu 4508 dx cap.826 100uf 160 v | vicena |