Aiwa Repair Tips
Search: aiwa
Results: 315
Results: 315
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| AIWA |
NSX-F9, NSX-F98, NSX-F99, NSX-F12, NSX-F15
|
Does not select disks | R424, ic403, chaves 5451 a 5456 | ||
| AIWA |
NSX-F9, NSX-F98, NSX-F99, NSX-F12, NSX-F15
|
Engine with wrong rotation | Q1, r4 | ||
| AIWA |
NSX-F9, NSX-F98, NSX-F99, NSX-F12, NSX-F15
|
Deck motor does not work | Q501, q504 | ||
| AIWA |
NSX-F9, NSX-F98, NSX-F99, NSX-F12, NSX-F15
|
No audio | Ic801 | ||
| AIWA |
NSX-F9, NSX-F98, NSX-F99, NSX-F12, NSX-F15
|
Micro doesn't work | 601, j621, q600, ic603 | ||
| AIWA |
AR295
|
Lack of color (green) | R904 | ||
| AIWA |
AR-205
|
Greenish screen (without red) | D902=bav21 | ||
| AIWA |
NSX-229
|
Display almost off | Q105 and the 10r protection resistor connected to it. | ||
| AIWA |
NSX S222
|
If you increase the volume, the device turns off | Found to be defective in the boxes. | ||
| AIWA |
VXT1400
|
When switching to stby raster remains and buzz noise is heared from the speakers | Cause: +b voltage 103 v does not switch-off. remedy: replace defective c541 | ||
| AIWA |
CX-NS 559LH
|
Only std led by lit | Q103 open 2sa1235 | ||
| AIWA |
VXT1450K
|
Field collapse | Fr812 3r9 1w fusible o/c - no other fault found | ||
| AIWA |
VXT1420K
|
St/by only | Loptr leaky | ||
| AIWA |
VXT1420K
|
Dead | Start up res r502 1m & r503 820k | ||
| AIWA |
VXT1410K
|
Poor start up from cold, patterning | C522 2µ 50v, c523 100µ 50v | ||
| AIWA |
VXT1410
|
St/by only | Dry joints power/stby key | ||
| AIWA |
VXT1400KER
|
Red weak in pic | Replace c905, 7 & 9 1µ 50v in rgb drives | ||
| AIWA |
VXT1010K
|
No cold start up | C524 47µ 10v | ||
| AIWA |
VXT1010K
|
Int sw on | Replace stk73907, c514 0µ082 pulse cap, q501 2sk212, q510 2sc1815. change r520 to 68k & c524 to 220µ | ||
| AIWA |
VXT1010K
|
Dead - goes into st/by | R515 3m3 , c517 c526 470uf 10v , c524 47uf 63v |