Cce Repair Tips
Search: cce
Results: 4834
Results: 4834
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS2991 FS
|
Led power off wk +b not secondary | C816 sold out | ||
| CCE |
HPS2985
|
Retrace lines, washed screen (white) does not operate controls (buttons) and no sound from channels, inhibits (sda & scl) | R901(22r), does not power (rgb) & inhibits (sda and scl) | Alextecnico | |
| CCE |
TV2118USP
TV2118 |
With the image jagged and warping??? | C-417 I changed it and it was ok....blzzz | C-417 | neupsx4download |
| CCE |
HPS 1497
|
The LED turns off and it doesn't turn on (it oscillates) | Ver for 402 | Master Eletronica | |
| CCE |
HPS-3407B
|
Burning ic 301 ( tda8359j ) and fr423 | Exchange q802 and q805 of bc337 for bd135 without measuring. put another tda and another fr423 | paulorusso | |
| CCE |
HPS 1470
|
Ñ league. | Q 402(bu2527dx) | Replace the same | BARRETO CRUZ |
| CCE |
HPS2198
KK |
Turns on with LED flashing without video crown opening the case turns red | Q909 | Q909 | fernado tj maçeio |
| CCE |
HPS-2907FS=HPS-3407FS
|
It doesn't turn on, the filament lights up and there is no image hitting the tube plate, it turns on normally @@@ | In my case, I solved all the solder bridges on the PCI PLA tube, the defect was resolved. | Help yourself leave your tip | ELETRONICA ARNI-SC /L.LEAL |
| CCE |
HPS 2171
|
Does not turn on LED blinks | Power supplys do not stabilize capacitor c824 | Domingos da Eletronica | |
| CCE |
HPS 2198
|
When plugged into the socket, the volume turns on and works less | Touch on/off key | Domingos da Eletronica | |
| CCE |
HPS 2997 FS
|
Turns on but no video, no blue screen | TRC D902 board diodes, 3, 4 exchange without measuring | Domingos da Eletronica | |
| CCE |
HPS-2197 FS
|
Turning on and off or arming the relay and the LED flashes without an image. | C825 [47uf/ 160v] with one of the terminals broken. | If not, I used 33μF/ 160v and it worked without problems. | Altevirlima_Valparaiso Eletrônica_PA |
| CCE |
TV29USP
|
Replace it. This TV came from another workshop and the two power supply fets had been replaced and it was getting too hot, I put the two original fets in and bingo it was ok. | R812 0.22r open | Replace it. This TV came from another workshop and the two power supply fets had been replaced and it was getting too hot, I put the two original fets in and bingo it was ok. | antonio nobrega(patos pb) |
| CCE |
HPS-2185FS
|
Stop | R423 of 4k7 on the line (abl) toast, caused by a defect in the flybak | Swap, the same and also flyback | |
| CCE |
HPS 1407
|
It works normally and after a few minutes it pulls the image to one side of the screen with white clouds. | Defective r414 | To replace | eletronica visão ibirapitanga ba |
| CCE |
HPS2071
|
Does not turn on, power supply +b zero | Capacitor c805 de 150mf/385v seco | Replaced c805, resolved. | PATRICK |
| CCE |
HPSAVP E GENéRICOS
|
Replace c831 of 1000mf/16v for one of 1000/25v | +16v a little low, and c831 swollen, but measuring normal. I had never seen them use insulation of a capacitor equal to the nominal voltage, 16v power supply and 16v capacitor, things from CCE. | Replace c831 of 1000mf/16v for one of 1000/25v | jasvan souza |
| CCE |
TVS-2910 FS
|
Horizon. closed | C-408 e c409 | joelton | |
| CCE |
HPS2071
|
The LED starts flashing with sound and the screen is dark when the screm increases, the screen turns white, horizontal lines appear | Q901,q902,q903,q904,q905,q906. After the replacement, the TV worked normally. | BETO ELETRONICA ACRELANDIA ACRE | |
| CCE |
HPS2981
|
I'm here | L 101 open | edezio eletronica |