Cce Repair Tips

Search: cce
Results: 4825

Make	Model	Symptom	Problem	Solution	By
TV CCE	HPS 2185SF	Increase and decrease volume turn off change channel	Change all touch switches on the front panel		leonardo souza costa
CCE	HPS-2971	When the frame increases in volume on the sides, it starts to sway	Photo coupler with leak between pins 1 and 2, and the transistor shorted smd q808	Replace of photo coupler ic803, and q808, zener dz811....	house eletronica ltda
CCE	HPS-2088ST	When turned on, the LED would flash about three times and turn off, check the 103v and 16v power supplys, both low.	I replaced the 823 diode and everything worked again.		Alvanyr This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2991	Dark band on the left side, image saturated in all directions, screen seems too busy	18k open resistor, r401	Replace of the same	macceletronica
CCE	HPS2071	Turns off after 15 minutes	If you don't want a return, change everything-q802-q804-c805-c825-c829-ressolde fr401		HP ELETRONICA
CCE	HPS2991	LED doesn't light up	C-816		joelton
CCE	HPS 2002 D	Inoperative burnt horizontal output	I replaced the horizontal, it got hot and burned, causing resistor r411 4k7 changed value	I replaced the 4k7 resistor with 8k2, it says 6k8, the transistor behaved normally without getting too hot	adriano alex
CCE	TVD2901	Varying the frame on the screen as if it were a power supply varying	C421 short, abl circuit		Bruske
CCE	HPS2971	Varying the frame on the screen as if it were a power supply varying	C421 short, abl circuit		Bruske
CCE	HPS1407		Cause: faulty ic 802 tl431		klein
CCE	HPS 1471	Vertical works only the bottom half	D301	D301	DIGITAL TEC
CCE	2118 14	TV turns on and off with half the image closed	Ceramic condenser that goes on the deflector pin	I replaced it, it was 3312kv, it was black	negodrama
CCE	HPS2971	TV doesn't work, just lights up on standby (flashing)	Q806 (smd) shorted		This email address is being protected from spambots. You need JavaScript enabled to view it. Bruno Nicacio
CCE	HPS2907 FS	Vertical dash on the screen	C409 , 394j 250v	Barter it	This email address is being protected from spambots. You need JavaScript enabled to view it., jaicós PI
CCE	HPS-2185FS	When turned on, the LED flashes and the relay activates	Fly back com screen alto	After racking my brains and changing several components without results, I adjusted the fly back screen. Finally the LED stopped blinking.	This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS 2092	Not starting	Cap.33.160v. e cap 47.160v	Replace the same	fernando ferreira
CCE	HPS2071	Right side black belt	0r22 resistor r813 with changed value	Replace the same	rafael pantoja ig-miri
CCE	HPS1415	Horizontal line in the center of the screen, i.e. closed vertical.	Ic301=an5512 or ka2131 the shorted equivalent, with the short the r420=1r opens and to be sure if the ci is shorted, clean pin 4 of the ci with the sucker, if the voltage normalizes, replace it.	The ci an5512 and r420=1 r were replaced, and it was... ok.	Armando Olímpia.
CCE	HPS1401 H	Only the vhf signal comes in, that is, no uhf signal comes in.	Causes defect in ic101=33v zener.	It gave the impression that it was a defect in the varicap, but the zener was replaced and everything was... ok.	Armando da Eletronica S´Tv, Olímpia Est:de São Paulo.
CCE	HPS1403B	Dead power supply	Open 27k resistor r801		Eletroclaudio Aguas Belas PE