Hitachi Repair Tips
Search: hitachi
Results: 1065
Results: 1065
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| HITACHI |
CPT2488 SAL K
|
Blanked out pic except for top and bottom of scr | C574 100mfd , 40v | ||
| HITACHI |
CPT2488
|
Blanked out pic apart from strip at top & bottom - improves with heat | C574 100µ 40v in field timebase | ||
| HITACHI |
CPT2476
|
Int power off | Focus spark gap dirty & int arcing | ||
| HITACHI |
CPT2476
|
Bright pic varying left to right | Cap in 200v supply on crt base | ||
| HITACHI |
CPT2288DS
|
Standby - led on - dead. | Ll04 o/c - may be able to unwind & refit. | ||
| HITACHI |
CPT2288DS
|
St/by only | No o/p from sw mode psu as ll04 coil o/c | ||
| HITACHI |
CPT2282
|
Dead aft degaussing therm blown | Replace mains fuse & thermistor (p181 from chs works) - won't work without this dual role therm | ||
| HITACHI |
CPT2250 J
|
No startup. | I will go 12. | ||
| HITACHI |
CPT2218
|
Field cramping | Replace c608 22mfd250v | ||
| HITACHI |
CPT2218
|
Field cramp | C608 22µ 250v | ||
| HITACHI |
CPT2198
|
Blank white raster | C720 in rgb 200v supply | ||
| HITACHI |
CPT2188 IPSALO
|
Line tearing + int blue screen | Pin 13 icb500 should be 11v if not replace tda 2579 | ||
| HITACHI |
CPT2188 IPSALO
|
Int won't start | C604 1000uf 25v | ||
| HITACHI |
CPT2188
|
No display or tuning | Cc107 220µ 16v by saa1294 control chip | ||
| HITACHI |
CPT2188
|
Int failure to start | C604 1000µ o/c | ||
| HITACHI |
CPT2176
|
Field - top foldover | C682 1000µ 50v in fop stage hi esr | ||
| HITACHI |
CPT2158 NP85CQMK2
|
Poor pic - dark & streaky | Zd801 3v3 zener on crt base leaky | ||
| HITACHI |
CPT2158
|
Blank raster & max sound | No 5v to micro - d911 dry joint | ||
| HITACHI |
CPT2138
|
Blank grey raster, no sound for first few mins | C922 470µ 25v hi esr | ||
| HITACHI |
CPT210
|
Bright raster esp on rh side with smearing | 200v supply to crt pcb low due to c719 4µ7 250v o/c |