Itt Repair Tips

Search: itt
Results: 521

Make	Model	Symptom	Problem	Solution
ITT	DIGI-3	Dead - blowing fuses.	Frame ic s/c ic401 ( tda217p )
ITT	DIGI-3	Colour - flickering.	Ic650 ( vcu2100 )
ITT	DIGI-3	Blank raster - no sound.	Ic mda2061 ( sel3776 52 07 ) on front unit.
ITT	DIGI 3	There were three alternative fault symptoms with t	A cracked joint at one of the primary winding pins of the standby transformer produced the no go problems. the sync problems
ITT	DIGI 3	The picture looks cloudy.	Frame ic tda2170 , plus change 100uf c402 or c602 by it.
ITT	7180	No sound - just buzz	Adc2310 audio proc chip ic3101
ITT	7180	Hiss only from left speaker	Ic3201 apu2470 on audio/scart pcb u/s
ITT	5861	Tripping.	Bu208.
ITT	4835	Standby - going into standby int.	Ht preset incorectly adjusted.
ITT	3621	Noise on pic then e/w dist & narrow	T541 bc637 & r539 1k faulty due to overheating & dry joints c521
ITT	3538	St/by only - ht low at 40v	Lopt (fat3806 or hr6057)
ITT	3493	No r/c, sound or col	Saa1251 r/c dec chip
ITT	2705	Tripping.	Bu208.
ITT	1660	No colour.	C721 ( 100u f ) o/c.
ITT	1611	Dead - int.	Dirty contacts on on/off switch relay.
ITT	90	Dead.	R405 ( 820k ) o/c
ITT	30	Focus - control aching.	Change crt base not just the control - it will do again.
SGO ITT NOKIA	51 - 005C Mono Print	Does not perform functions display presents itself with 88	Lack of 5 volts on line ix ic 1404 = l 78 m 05	Sub regulator ic1404 = l78m05
SGO ITT NOKIA	51 - 005C Mono Print	Does not perform displey functions presents itself with 88	Lack of 5 volts on line ix ic 1404 = l 78 m 05	Sub regulator ic1404 = l78m05
ITT NOKIA SHAUB LORENZ	20 STD Cor Kit	Doesn't start	Faulty mat transistor causes oscillator changes (leakage)	Printed circuit of the power transistor cooling plate (resoldering mass)