Itt Repair Tips
Search: itt
Results: 521
Results: 521
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
ITT |
SP71D1
|
Dead with s2000af lop tr s/c | Failed aft replacement - ck51 8n7 1.6kv faulty | ||
ITT |
PICO S3
|
Dead apart from brief led flicker at sw on | Loptx | ||
ITT |
PICO S3
|
Dead - life restored if scan coils dis'd | Width control coil on scan coils has shorted turns | ||
ITT |
PICO S2
|
Dead - no relay click or display | Mains st/by tfmr o/c pri | ||
ITT |
PICO S2
|
Dead - no relay click at switch on. | Standby mains transformer primary winding o/c. | ||
ITT |
PICO S
|
St/by only | Relay clicks at sw on but no ht to lop tr; c701 10µ 350v faulty | ||
ITT |
PICO S
|
Pulling/bouncing/int loss of sound | C212 10µ 50v in cmr800 (top of can) | ||
ITT |
PICO S
|
No sound | R1075 3r3 safety res o/c; c229 220µ s/c | ||
ITT |
PICO S
|
Misty pic - poor col with red flaring | Earthing ring on crt base shorting to cathodes | ||
ITT |
PICO S
|
Int dead when heated | 115v ht still present; dry joints lop tr | ||
ITT |
PICO S
|
Display shows "88" | Saa1292 chip faulty - caused by dry joints esp on c10 1000µ | ||
ITT |
PICO S
|
Dead. | Check small lt transformer for o/c. | ||
ITT |
PICO S
|
Dead | 2a fuse on front panel o/c; degauss therm caused it | ||
ITT |
PICO S
|
Blank raster with line tearing - sound int | C524 10µ | ||
ITT |
PICO S
|
Bad hum bar & no sound | Replace 4 x 1n4007 mains rects | ||
ITT |
PICO 1A
|
Tuning - will not tune in. | R1154 ( 2.2k ) o/c , d1151 ( reads ok ) | ||
ITT |
PICO 1A
|
Dead - with rapid ticking | No ht - d658 120v zener leaky | ||
ITT |
PICO 1
|
Picture dark ( not a1 supply ) | Line 1 | ||
ITT |
PICO 1
|
Dark pic | Tda3561 u/s | ||
ITT |
PICO
|
Will not startup - ltb loaded. | Disconnect scan coils if sounds better then loptx. |