Search: itt
Results: 521
Make Model Symptom Problem Solution By
ITT FT110
Colour - phasing varing. C818.
ITT EUROMONO 2
Lack of height from cold 6c10 220µ 35v
ITT EUROMONO
No colour. 13ic04 ( tvp02066 em0302 ) pt no.3779-12-24 )
ITT EUROMONO
Int picture floods red with flyback lines. Ic1002 ( tea5101a ) on crt base.
ITT EUROMONO
Blank raster with flyback lines. No 185v to crt base , 5r56 ( 4.7r saftet ) o/c.
ITT EURO STEREO2
S2000af line o/p tr int goes s/c; line dr tr goes o/c Line driver tfmr
ITT EURO MONO 2
Dead apart from faint squeak 5t10 lop tr s2000a leaky; 5c38 10nf - 33nf dry joint (depends on model)
ITT DIGI-3
Picture unstable when warm. Dpu ic faulty.
ITT DIGI-3
Picture shifted half way down. Replace d411.
ITT DIGI-3
Patterning effect. C209 ( 47uf ) , c234 ( 10uf ) in hf module.
ITT DIGI-3
No or intermittent remote control. Fit a 10k res between pin 6 and chassis ic404
ITT DIGI-3
Line sync pulling. C209 ( 47uf ) , c234 ( 10uf ) in hf module.
ITT DIGI-3
Horizontal bars over picture. Ic 1403 tuner interface ic.
ITT DIGI-3
Frame - height reduced at top - bottom ok. D411 ( ztk 6.8 zenor ) breaking down.
ITT DIGI-3
Frame - blank line at top of picture. R431 o/c.
ITT DIGI-3
Colour - colours not correct. X610 17m7 hz crystal faulty , pvpu ic630 faulty.
ITT DIGI B
Dead or int dead/ reverts to st/by etc Mains i/p choke dry joints
ITT DIGI 3 110DEG
No sound/raster - ok on dummy load D547 in 13v supply s/c & fop chip tda2170 ic401 s/c
ITT DIGI 3 110DEG
Dead with st/by light flashing Tda2170 field o/p chip s/c
ITT DIGI 3
Whistles , chan ind lights then elec fuse operates Check field stage - d547 , tda2170 , c548