Itt Repair Tips
Search: itt
Results: 521
Results: 521
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| ITT |
PICO
|
Dead - psu not operating | Zpy120 120v over volts zener leaky | ||
| ITT |
MP37H
|
No sound via tuner - ok via scart | Surf mount tr va02 bc847 leaky b-e - pulled down pin 1 of tda8362 audio de-emphasis | ||
| ITT |
MONOPRINT B
|
Txt inoperative - indicator works | Dpu2540 chip on txt panel | ||
| ITT |
MONOPRINT B
|
St/by only with eht present | C722 | ||
| ITT |
MONOPRINT B
|
St/by only | C715 | ||
| ITT |
MONOPRINT B
|
St/by only | Ht at chopper tr - replace c701 4µ7 400v o/c; bu508a lop tr leaky | ||
| ITT |
MONOPRINT B
|
Slow startup. | C704 ( 47u f ) , c701 ( 4.7u f ) may check ok. | ||
| ITT |
MONOPRINT B
|
Slow start up from cold. | Change c701 , c722 ( 470u f 16v ) , c711 , c707 , r512 | ||
| ITT |
MONOPRINT B
|
Slow start up | C701 & c707 | ||
| ITT |
MONOPRINT B
|
Sizzling noise followed by thump then dead. | Pin g of chopper tx dry. | ||
| ITT |
MONOPRINT B
|
Pic pulling/flickering - ok on scart | C201 4µ7 in tuner hi esr | ||
| ITT |
MONOPRINT B
|
No sound | C304 470µ (pin 5 tda8196 ic301) | ||
| ITT |
MONOPRINT B
|
No control via front controls | Keypad defective - try cleaning | ||
| ITT |
MONOPRINT B
|
No cold start | C722 470µ 16v (8v smoother)- note wrong markings on pcb top | ||
| ITT |
MONOPRINT B
|
Int dead | Dry joints chopper tfmr | ||
| ITT |
MONOPRINT B
|
How switch mode psu works. | With ccts. | ||
| ITT |
MONOPRINT B
|
Dead - tripped | Loptx or s/c lop stage | ||
| ITT |
MONOPRINT B
|
Dead - pri psu ok | Dhaaa & Saaa4 | ||
| ITT |
MONOPRINT B
|
Dead - no 115v feed to line stage. | C701 ( 4.7u f ) in psu. | ||
| ITT |
MONOPRINT B
|
Dead - low ht & no eht | Loptx - scope loptr coll - has lots of spikes |