Lg Repair Tips
Search: lg
Results: 4875
Results: 4875
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
CP20B84
|
Dark stripes over the image | C540 (4.7mf x 250v) | ||
LG |
CB20F84SX CHASSIS BEKO 12.4
|
Does not tune in to any station | Replace the tuner. | ||
LG |
CB20F84SX CHASSIS BEKO 12.4
|
Does not turn on. standby LED is on. | Replace r623 0.1Ω interrupted. | ||
LG |
|
||||
LG |
CF-28A56T CH PC-73A
|
No horizontal deflection (vertical stroke) | Cold welds on the deflector plug (on the deflector itself) | ||
LG |
CB21T20X
|
Negative image (film type) | Replace c539 | ||
LG |
CHASSI BEKO 12.7
|
Power power supply. doesn't always start | C610 10nf (smd) with slight leakage | ||
LG |
CB-14F80 -BEKO 12.1
|
Image folded from the middle upwards and shaky. sometimes, momentarily, it was ok | Diode d502 1n4001 defective despite measuring well. | ||
LG |
CF-25C28T, CHASSIS PC58A
|
To avoid burning ic351 tda8350q too often. | Subst. fr351 1r 1w >> 3r3 2w, e fr359 10r 1/2w >> 47r 1w | ||
LG |
45I
|
Yellowish image in the center | 1uf 160v c345 on kinescope board | ||
LG |
710E
|
Without one of the colors | Lama 476 tb | ||
LG |
CP20B8S
|
Osd flickering | Bad new fly. | ||
LG |
9311
|
The color system is in PAL-G, I need to change it to NTSC | To change, hold the CR pause key for a few seconds. | ||
LG |
CP-20J52A
|
TV with drizzle. does not tune in to any channel. voltages on the normal selector | D22 on pin 57 of ic501 shorted. | ||
LG |
LM-U1350A
|
No audio | Diodo d941 | ||
LG |
14CB25A
|
Vertical closed | Check electrolytics d301 and d302, replace c303 | ||
LG |
RP-21FE85G
|
No Audio | Before replacing components in the Audio line, check TV parameters. enter service mode, change snd mode to (2real st) | ||
LG |
21FE85
MC-059A |
Turning off | Check r423 - if the value is 3k or 1k, place a 12k resistor | ||
LG |
44M STUDIOWORKS CHASSIS 32
|
When starting the computer, the boot and extended memory sign appears normally, but when starting Windows, the screen is white without any image. | The c.i. 202 ( gvc 08001 ) was defective. After a long search, I finally found a used one. After replacement, the monitor started working normally again. | ||
LG |
440SI STUDIOWORKS
|
Sudden horizontal oscillations on the screen. Sometimes it almost completely loses its shine, then it suddenly becomes good. shatters the sides of the monitor. | Pin 02 of the fly back is +b, and must be fixed at 65 vdc. if it is varying, it could be the d701 or q704. The most likely is the 10k/1kv ceramic capacitor, it is right in front of the fly back 6174z-1003d. Note: in this defect, the technician usually changes the s,h. and the fly-back..., but without success. They are not the villains. Good luck my comrades. carlos |