Search: lg
Results: 4875
Make Model Symptom Problem Solution By
LG 7722N/7822N
R101 and r104 open.
LG D30/3C
Dead Cc503=100k cc504=100k cc505=47k
LG FLATRON 563SL
Screen shaking C 100u/16v altered
LG 29C85
Dead R831 and r437, check high output.
LG 29C85
After 50 seconds on, the TV closes the vertical position, mutes the audio and turns off, remaining in stand by, no longer turning on. after a while off it starts working again Cold solder. Check welding on all cis, transistors, connectors and high power resistors and the TV started working again.
LG CI29H40 PC8KA
There was a bright white screen with flyback lines on this set. the a1 adjustment had very little effect I found that ic901 tda6108jf on the tube base was faulty, pin 7 blue o/p and pin 8 green o/p both read s/c to ground. note: this chip was probably taken out due to the tube flashing over as in my case
LG CZ-20E60 11.1
Stuck in standby with no line drive R410 o/c
LG CF-28A50T PC-58A
Flyback lines on pic Check resistor r351 in front of tda8350q. it should be 3.6 k. i replaced with 3.8 k and it worked fine. additionaly check: r708, fr704, fr359, q351, q345. if fault persists try replacing the tda8350q
LG 21FB32
LED stays on, but no image or sound appears Ic 805 (se110)
LG RP-14K40
Power supply does not turn on Ic501 * 1231cn
LG RP-14CB20A
No audio R624 - 22k
LG 21M21MQ
TV turns on, works for a few minutes and then turns off. R831(123k 1% tolerance) changed
LG RP-20CC20
SC023A
White screen strobe effect Replace cinescopio socket
LG VARIOUS
Modifying r/c to access service modes There is a service remote availiable but if you have a remote which uses an saa3010t ic , simply connect a tact switch between pins 1 & 11 to access the service mode .
LG LV710
Wont tune - "safe" displayed Sus eeprom
LG KE14U73 COMBI
Swirling lines & static pops on pic Poor earthing of the deck to the screen large vcr screening can
LG KE14U73
St/by only Ht present but no 8v supply to ic500 jungle chip pin 37. d850 in psu leaky
LG CI21T24F
St/by only - red led lit no power to psu pri Dry joints rl108 relay
LG CI20E20
Dead with strs5707 chopper chip & bridge rect s/c Also replace 4 x elects in psu
LG CI14B50F 11.1
St/by only - no line dr No 12v supply to line dr trfmr tr101. check back from pin 15 chopper trfmr - r410 0r1 o/c & dry joints chopper trfmr