Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
CT15MS1TX
|
Sound but no picture. brightness, contrast & colour all at minimum. returning these settings to normal brings back the picture but they return to minimum if the set is switched off then back on. | Replace faulty x24c04p eprom (ic702). | ||
| MITSUBISHI |
CT15MS1TX
|
No sound/pic all ht volts ok | Ic702 x24c04 eeprom replaced | ||
| MITSUBISHI |
CT15MS1TX
|
Low sound aft being in st/by | Eprom ic702 changed | ||
| MITSUBISHI |
CT15M2TX
|
Int off | Ic901 (str54041) int | ||
| MITSUBISHI |
CT15M1TX
|
Field collapse - partial or total | R563 0r82 o/c | ||
| MITSUBISHI |
CT1535TX
|
Stuck in st/by - red light only | Replace str54041 - only works properly with mitsi version | ||
| MITSUBISHI |
CT1525TX
|
St/by only - q552 loptr 2sd1877 s/c | Check dry joints line dr trfmr & str54041 ic901 | ||
| MITSUBISHI |
CT1525TX
|
Dead with squeal | Loptr 2sd1877 leaky - no other fault found (on sw on front) | ||
| MITSUBISHI |
CT14MV1B
|
Dead | D6313-6 mains rects s/c, r3337 2r o/c, tr7330 s/c, d6332 & d6337 s/c, ic7310 mc44603 also replaced & r3338 39r fusible o/c | ||
| MITSUBISHI |
CT14MV1 PHILIPS
|
Dead - shuts down straight away when bringing out of st/by - prot cct activated | To deactivate prot cct remove plug 1923 on tv/ltb board. this gave 2" band across screen. pin 8 fop chip ic7510 low at 1.5v (11v). 32v line low at 11v - ic7331 reg tl431clp faulty | ||
| MITSUBISHI |
CT14MS1TX
|
Won't tune or store - pic blacks out when receiving rc command | Ic702 x24c04p eeprom | ||
| MITSUBISHI |
CT14MS1BM
|
Pic shifted to right | Dry joint r527 near lopt | ||
| MITSUBISHI |
CT14MS1BM
|
Intermittent field jitter . | Dryjoint at r461. | ||
| MITSUBISHI |
CT1447BM
|
Dead | Ic901 str44115, d906 (rg2) protection diode, r901 (4r7/7w) and c921 (47µf/50v). | ||
| MITSUBISHI |
CP1424B
|
Vertical ringing on left hand side of screen. | Poor earth connection to c905 ( 33uf ) in psu. | ||
| MITSUBISHI |
CP142
|
Frame - jitter & intermittent roll. | Q431, Q432 (2 Q11A) | ||
| MITSUBISHI |
CM21M5BT
|
Dead | Q901, r991, ic901, d909, c914 & q552 replaced. a bu 508df or bu2506df works in place of bu2506dx q552 | ||
| MITSUBISHI |
C37C2STX
|
Dead with red led flickerinmg | C959 470µ 16v in reg cct faulty - at front of pcb | ||
| MITSUBISHI |
C37C1STX
|
Purity int | Crt faulty - loose shadowmask - replace crt - not a task to be taken lightly! | ||
| MITSUBISHI |
C37C1STX
|
Pic in pic in black & white | Q608 jc501q,r on main pcb s/c |