Panasonic Repair Tips
Search: panasonic
Results: 2909
Results: 2909
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
TC-32CS600B
|
Turns on without image with sound and then turns off | Burnt out backlight LEDs. gives the impression of another defect | Stiltec | |
| PANASONIC |
TC-32CS600B
|
League without image with sound | Burnt out backlight leds | Replace the bars | Stiltec |
| PANASONIC |
SC-HT75
|
Language but the sound disappears after a few seconds, the panel remains lit. | Dc on the left output of the surround speakers, system goes into protection | Changing the output ci or isolating the left surround output, pin 1 of the audio output ci. | José Dias |
| PANASONIC |
TC-L32C5B
|
Turns on, turns on the backlight momentarily and turns off, indicating the 3-blink error code on the LED. | Check for a short in the 2 smd capacitors under board a (main board) they are close to the silkscreen "q4153" going diagonally to the right, it could be the top or bottom capacitor, don't forget to change the smd fusistor that is connected to series on the line, it has the letter "n" written on the body, the capacitors must be replaced, the capacitance is 5uf each, use larger smd capacitors so they will have a higher insulation voltage. | Replace all components and check for shorts. (tec edfersom. varjota-ce) | Edfersom |
| PANASONIC |
TC-L32B6B
|
TV keeps flashing red, voltage is 16v, plugs it into socket, it appears 15.4v then goes to ov | LED bar burned out, TV won't turn on, screen off, no sound | JOAQUIM ROSA | |
| PANASONIC |
TC-14A02
|
Does not connect power supply +b less than 140 volts | Cause diode. | Replace diode d1132 or remove from board | renildo |
| PANASONIC |
TC-32A400B
KM26 |
TV completely inoperative, stand-by LED does not light up and power supply voltages are absent. | Remove the jumper resistor vj2001 and place the TV in the socket and if it turns on, check for a short in the audio output... in my case the problem was in the shorted capacitor c4901. | ROBERVA1 | |
| PANASONIC |
TC L32-B6B
|
Does not turn on, vd led blinks then comes back on and vm stand by led stays blinking | Defective led bars. | KRUL | |
| PANASONIC |
40FS600B
|
Blinking red LED non-stop | Capacitor and regulator near the usb port in short (ic8453) | Remove and replace them | Andrei (051)991421340 |
| PANASONIC |
TC-L42U30B
|
Flashing red LED 14x | Tpc8116 mosf failure | Remove the tpc8116 mosfet and connect the 3 power pins | BETO ELETRÔNICA ACRELANDIA AC |
| PANASONIC |
SA-AKX16
|
After changing the integrated ic1002, ic1003(54240), r1042 of 0 ohm that was open, the device turned on, but it showed f61 on the display and then turned off | Shorted sound output (tas5612la) and three more open 10r resistors, as tsound are no reference numbers on the board, just download the diagram online | After exchanging these components the device worked perfectly | PATRICK ELETRÔNICA |
| PANASONIC |
SC-AKX52LB-K
|
Doesn't start | Ci mip2f2 in position: ic5799 short also checks the t5751 trafo | Exchanging it and running for the hug | Airton Filgueira |
| PANASONIC |
SA-AK25
|
Device on standby ok, needs power displays f61 | Usage time, worn-out lifespan. | Resolder the amplifier board, including the regulator transistors. | Eletrônica Barros |
| PANASONIC |
TC-14RM10L
|
Does not turn on, LED is on and +b with only 15v. | Check if tsound is 130v on pin 1 of ic802, if not, replace it | MARCONES DE ARARIPINA-PE | |
| PANASONIC |
TC-14RM10L
|
Does not turn on, no voltage on the +b of the flyback | Open 10r resistor r520 and r521. | MARCONES DE ARARIPINA-PE | |
| PANASONIC |
TC-L39B6B
|
Image only half | Defective image | Lenivaldo matos | |
| PANASONIC |
TC-32A400B
|
When the TV signal turns on, it turns off and the standby LED flashes 9 times | I noticed that the sound was strange, when I opened the TV I also noticed the speakers were ripped, I measured it and the impedance was very low | I replaced both speakers and the TV returned to normal. | GR Eletronica |
| PANASONIC |
TC-32FS600B
|
Sometimes it turns on and sometimes it doesn't turn on and it locks up to the functions of both the remote control and the buttons | Smd diode in position d2851 remove the glue underneath it and that's it | Cleaning the smd diode in position d2851 | Airton Filgueira |
| PANASONIC |
SA-MAX 750
|
Turns on and then turns off, or the display remains weak and the coolers too | Q 1803(a1271) and capacitors c1306 and c1651 with high esr | Luis fischoeder | |
| PANASONIC |
TC-L32U30B
|
LED flashes red 3 times | 1uf capacitor c4141 shorted | Behavior replace | Rafael |