Panasonic Repair Tips

Search: panasonic
Results: 2909

Make	Model	Symptom	Problem	Solution	By
PANASONIC	TC-14RM15L	TV turns on normally but in the av it's dark	R557 replace and run for the hug		vídeo som (Escada-Pe)
PANASONIC	L42D20B	Does not turn on and the red LED flashes 4 times	Cold solder on terminals 7 and 8 of the t301 that feeds d753 is d755 killing the 12 volts.	I redid the soldering, the TV started working again	luiz
PANASONIC	TC40C400B	Turns on and off, 2.3 times, when it turns off standbay flashes and goes to red	Defective LED, you can go without fear, defective LED		Claudio Eckert
PANASONIC	TC L32U5B TCL32U5B PANASONIC	When turning on, the green LED flashes in sequence with a blink interval.	Metallic capacitor c 9353 exhausted, measure the 5v variation when turning on the backlight that drops.	C9353 replace.	Jadson G Nascimento
PANASONIC	TC-20A12	Image with colored lines at the top of the screen horizontally, about 10 cm.	Capacitor perto do vertical, 100u/50v, so replace.	100 by 50v layer	marcos- Confresa, MT
PANASONIC	SC-AKX14	Display only turns on and off	3.3 regulator on main board	Just replace	Binho Poções
PANASONIC	TC-L39B6B	TV does not turn on without STBY, main board shorted, after repairs, TV activates STBY, blinking three times, 16V audio error	Main board, short capacitors, power supply board ruptured smd fuse.	Main board replace smd capacitor, the side av output is at the top, at the power supply replace the smd fuse pa7402	RNSPTEC
PANASONIC	SA-PT75 RJBX0647BA	Turns on, hits the relay and turns off - protection or error f61	Electronic capacitor at smps, close to the str - change c5726 and check the cold welds		HOMETHEATER
PANASONIC	SA-AK27	The stanby LED only stays on, when the power key is pressed, the relay hits but nothing turns on, not even the display	Yellow fuse on the secondary of the power supply board open (fixed board on the transformer) and shorted diode d505 (on the amplifier board)	Replaced the components and it worked. the diode I put an in4007	Antonio Zwirtes
PANASONIC	TC20A04 TNP4G269	It turned on and off in a few seconds.	D1140 was shorted, arming the protection.		Eletrônica do Jordão -PI
PANASONIC	TC-L32B6B	Burning leds	Voltage found on the LEDs, 75v. the expected is 66v. This model uses 3 bars containing 22 3 volt LEDs (each LED). the total sum becomes 22x3=66v. This (66v) is the voltage that the LED set supports.	Remove the resistors (20Ω) r251,252,253,254 and replace the value of r255 to 33Ω. the voltage will drop to 66.7v.	Evando Viana
PANASONIC	TC-40DS600BE	Backlight flashes 3 times and turns off	Main board memories	Replace the memories on the main board, otherwise replace the board itself.	Douglas
PANASONIC	TC-14RM15L	TV turns on normally and switches to AV when you put the converter on, the image is dark	The defect was the open 95.3k resistor r557 and one of 100k
PANASONIC	TC-L32C10B	I'm sound	Remove the transistor q5450		Bruno nicacio
PANASONIC	TC-L32B6B	All blue screen has sound	Measure the voltage of the t-with a lack of 12v, the main board came with 0v, close to the lvds connector, tsound are 3 smd capacitors, 2 small and another slightly larger one, I removed the larger one from the board, it was shorted c4002 4.7uf 16v smd it is killing the 12v voltage and replace On the other hand, the TV normalized the image	Defect resolved	André
PANASONIC	TC-32A400B KM25 / KM26	LED constantly burning	Standard voltage at the output for the LEDs - 70 ~ 72v	Remove the r7839 which is on the top and the r7825 which is on the bottom, leaving 64 ~ 66v	marcos
PANASONIC	TC-32A400B	Dead	Oxidation on the signal board	Resolder transistors and smds capacitors.	Multimarcas/Acarí
PANASONIC	TC-P50V20B	Doesn't start	IC501 insulation broken.	Replace ic501 and f501.	electronics supply parts - Gramado/RS
PANASONIC	TC-20G12	TV keeps hitting the relay	The cause was the 2kv capacitor c565 222j		naelson silva gravata pe
PANASONIC	TC-32A400B	Doesn't start	A ram at the power supply, it only burned rifle	Replace rifle and remove ram	Dinho