Panasonic Repair Tips
Search: panasonic
Results: 2909
Results: 2909
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PANASONIC |
TC-L42U30B
|
Led flashes 14 times 15v low voltage with 5v customer 88178817 | R901 amended | Trade for a 36k | MARCOS MELO |
PANASONIC |
TC-L42U30B
|
Doesn't start. red LED flashes 14 times low power supply defect. it is giving 5 v on the 15v line pins 456 power supply cable | Doing a test on the IC 803 circuit I found a 30.1k resistor r901 changed, I put a 36k one and replaced it with 17 volts customer 88178817 | Replacing the r901 resistor with a 36k one click 88178817 | marcos melo ce |
PANASONIC |
TC-14A12
|
Power supply floating and turns off | Power supply coupler d807 | Replace of the same | ELETRONICA SALES.NATAL RN |
PANASONIC |
SA-AKX10
|
It turns on normally for a while and turns off. then it doesn't turn on anymore. | I found the capacitor in position c5817 at the power supply, exhausted. It was replaced and the sound worked normally again. | Carlão | |
PANASONIC |
TC-32C10B
|
Stop | 10rx5w open resistor | Replace resistor r880 10r x 5w near the relay and run for hug | VICTORINO |
PANASONIC |
TC-14RM15L
|
It turns on and off, the screen doesn't turn on and the standby keeps blinking | I removed the q581 and the TV turned on with half the screen closed. the cause was r405 of 2.7k | Resistor r405 de 2k7 | naelson silva gravata pe |
PANASONIC |
TC-39AS600B
|
Turns on, LEDs flash, turns off and remains in stand-by | Changed bar (check if tsound are any burnt bars) | Jumper r4, r9, r31 r33 (they are all gnd), note: I recommend reducing the voltage of the LEDs from 3.3v to 3.0v | Junior Souza |
PANASONIC |
TC21FX32L
|
When you plug it into the socket by pressing the power key, it just lights up the LED in green, then you pay and end up with the c856 charger, nothing turns on | Q850a1668short | I put another one from a scrap bimba TV, it focused well again | Marqueis eltec eletrônico |
PANASONIC |
TC-L32C10B
|
Turning off and seconds | Arcing in lamp sockets | Simply insulating and cutting out the burnt plastic was a breeze! good luck!! | Jhone eletronica |
PANASONIC |
TC-L42E5BG
|
League has sound without image all blue screen | Image appears and disappears, it is all blue Bad display driver, I changed the display | Defect resolved | Andre |
PANASONIC |
TC-L42E5BG
|
Does not turn on, green LED flashes | I checked the power supply, it's ok, I checked the main board, the voltages are fluctuating, ci usb2512b smd short, I removed it from its place, I turned on the TV, it worked, I put a new one in its place | Defect resolved | Andre |
PANASONIC |
TC-L42E5BG
|
Not working, does not turn on standby | Power supply makes a little tick tick noise, if you release the signal board it stops the noise. | Smd capacitor on the remote sensor board, the largest, closest to the sensor | Claudio Técnico - Ademir Eletronica - Surubim PE |
PANASONIC |
SA-AKX14
|
Doesn't start | C5805, c5808, d5801, d5802 and d5803 with cold welding. | Remove these components, test, resolder and run for the hug. | Vander CDs de Quixadá CE |
PANASONIC |
TV 29A11
|
Does not turn on power supply +b normal standby led on | Make a resoldering of the secondary power supply | EletronicaArni-SC | |
PANASONIC |
TC-L24X5B
|
TV doesn't even turn on | Capacitors c9110 and c9114 | I replaced the two capacitors and the TV stopped working. | Naguinho |
PANASONIC |
TC-14RM12L
|
TV with low sound | R257 56k | R257 replaced, just replace and that's it. | David jr. |
PANASONIC |
LC-L32G11B
|
Didn't tune in to any channel | An attempt was made to reset but even so, when searching for channel tuning, I couldn't find any, testing the voltages on the varicap, apparently all normal, removing the board to see what the underside was like, I found some lumpy stains. | The cake stains were removed with isopropyl alcohol, problem solved, the channels were tuned again. | Strutz |
PANASONIC |
TC-L32B6B
|
No image, just audio for a few seconds and turns off. | Back light with short LEDs and one open. | I lowered the circuit current. I removed the inverter resistors r258, r257, r256. the measurements were 66.8v and 305ma, with back light at 74%, for 63v and 192ma. | Eletrônica R-Tec |
PANASONIC |
SA AKX600
|
Doesn't start | Rectifier diode 36m5 shorted next to coil 330. | Resolved. | |
PANASONIC |
TC-L42U30B
|
TV turns on and after approximately 30 minutes it turns off | Transistor q817 was measuring 2.5v at the base and 10v at the emitter and collector | Power supply diode d840 with leakage | ADRIANO |