Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
EMOTION
CPH05 |
Without power supply, when removing the protection thyristor it comes, but high (turn off the three horiz output first). | 22k c921, or the str50103. | Measure the capacitor, if not changing the str. | jasvan souza |
| PHILCO |
PH29B
|
When turning on the device, there is no sound. After about 5 minutes the sound becomes hoarse | Tufted capacitors c833 and c829 | Changing these capacitors makes the TV work perfectly again. | SUPORTEC ASSISTÊNCIA TÉCNICA |
| PHILCO |
TPF2121F
|
It turned on but then turned off, all normal voltages | C 715 6n8 open | Substitute-lo | edmilson mendes |
| PHILCO |
PSC-3322V
|
Image with/cup shape | On some TVs, it opens r 722 of 10 r. in others it opens the r 702 of 150 k. Thanks to electronicacap. | feitosa | |
| PHILCO |
PH800
|
No sound turning off | Q5 2n3906 r212 220r | Replace q5 with bc557 | antonio nobrega(patos pb) |
| PHILCO |
PH14B
|
No image, removing the signal cable, blue screen appears | Leakage observed between the abl and 180v tracks, causing the resistors r462 of 3k9 and r463 of 3k3 to burn | Note: don't forget to scrape off the carbonization between the trails that leaked | GREIN Eletro |
| PHILCO |
PCM2044
|
Led lights up but does not oscillate secondary voltage of line plus b with 46 | 1000\25 c 915 capacitor from the 20 volt line with low capacitance | MACC ELETRONICA | |
| PHILCO |
TCM1446
|
TV with horizontal tilt and no RF signal | C722 470uf16v | I replaced it and everything was ok. | ELETRONICA IDEAL |
| PHILCO |
PCS-2976
|
Doesn't start | Cold solder d301 next to tda9373ps | ladmyr eletronica universal | |
| PHILCO |
PC 1438
|
It doesn't have 95 volts | Replace str 50103 | juci | |
| PHILCO |
PCM-1444
|
Out of tune | L001 on the 9v line. open. | Replace with 1 resistor of 1r x 1w. | Eletrônica Modelo (Jaicós PI) |
| PHILCO |
TV PH 21B
|
Does not turn on, LED is on but 5v is missing on the v502 | C509 220/16 shorted, connected to the v502 emitter | Replace to a 220/25v one | levicordeiro |
| PHILCO |
PCM 1444
|
Normal operation and after a while it turns off and on several times | Diode in4148 on the run, d301 on the abl line. | Replace d301 | MARX MONTE |
| PHILCO |
TP-2010
|
Stand by on, when the power key is pressed, after a few seconds it flashes. | R930 faulty, change and ok. | Cia do game eletronica - Lapa Pr. | |
| PHILCO |
PCS-2076S
|
Cuts the image and the sound remains black screen with white lines with characters. | Cause: r714 of 4.7r 1/2w and zd801 of 8.2v. | Replace. | Edigar de Souza Moulaz |
| PHILCO |
TP2054
|
TV doesn't turn on LEDs flashing quickly | D908 inoperative +12v | Replace the memo and everything is ok. | ELETRONICA MONITOR CELSO CAFELANDIA PR |
| PHILCO |
TP20V56
|
Sem as no rf no of normal | Deprogrammed memory | I did the reset, but then looking at some cold solders on the tube board I noticed that there was cold solder on the cable from the PCI to the tube board and then the sound came and went and if I touched the board the sound came back, resoldering resolved it. | HardNet |
| PHILCO |
PT-2053
|
Setting up protection | When pressing the power button, the LED turned off the TV, it started and oxidized but the filament did not light up, and it remained for about 5 to 8 seconds. and TV ficol ok! | Flyback | Mario teilor |
| PHILCO |
PCS2976, TPS2063-1453-1454
|
Audio ok, but no sound | Enter service mode and adjust adj, it takes it to 1, and returns to 0. | jasvan souza | |
| PHILCO |
TP2054
|
No sound | Eeprom | joao bosco |