Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILCO |
1451
|
It turns on (when cold) but if it turns off it won't turn on again | C 708 e c709 poliester | tyko | |
PHILCO |
PCM 2046
|
LED blinking TV won't turn on | Transistor q901 short, capacitor c915 dry | Replaced components | filipak |
PHILCO |
TP-2054
|
Shows the burnout of the vertical integrated | Change c 614 | This capacitor being shorted immediately burns the integrated | milton |
PHILCO |
TPF-2940
|
Voltage +b with 10v led on and it doesn't work if you press the power key it makes a noise and it doesn't work | D-919 byv26 | Put a new one in it was great | samuel leite |
PHILCO |
PCM 1446
|
Doesn't work | High power supply not working, I removed tsh and +b appeared, I changed tsh but the TV didn't work. capacitor c924 and c719 also defective | Replaced tsh and capacitors tv func ok | almirguarani |
PHILCO |
TP2054
|
The standby LED keeps flashing and makes a noise trying to oscillate | Diode d908 | Replace d908 which is shorted | Eletrônica Som & Imagem |
PHILCO |
TPF29S4F
|
Closed horizontally, cushion effect | R-1701 of 10r open | ladmyr | |
PHILCO |
PCM1444
|
Dead | R902(open) | To replace | JARBAS SANTOS |
PHILCO |
TP-2053
|
High power supply, device takes time to work | 19 | Take it out and measure it if there is even a slight replace causing the defect. | C.SOM |
PHILCO |
TPF-2941
|
Works and turns off after seconds | C805-47u/160volt's | jarbas santos | |
TV PHILCO HITAUTEC |
PCR 1447
|
Burning r 707 | Fly back ruim ov2094/d1 oub321087879-01b | Marcone | |
PHILCO HITACHI |
PC 1442
|
Has sound, screen opens and closes quickly | R 725 4r7 behind the fly back | Marcone | |
PHILCO |
TP2052
|
Image takes a while to appear when you just turn it on | Bad screen potentiometer contact | Replace the fly back or try cleaning the potentiometer with wd 40 | Alessandro |
PHILCO |
PCM 1444
|
Stand by LED on and does not arm the power supply | Q904 bc 546 with leak | pedro ironei jr | |
PHILCO |
PCM-2054
|
Cup effect, no characters, does not act tx | Deflector coil | Replace and if necessary adjust the height and linearity | Adrian Chapadão |
PHILCO |
PCM2046
|
It only has 30 volts where it should have 95 volts | Ic 901 str50103 | juci | |
PHILCO |
TP1453
|
If channel 5 appears, fi filter (mf 201) | Fi (mf 201) | Eletroinfor | |
PHILCO |
TP2054
|
League, but with a high screen and inclined vertical retrace lines. | R714 open, caused by short ceramic capac c803 on the rgb board. exchange the two components. | MANTENOPOLIS | |
PHILCO |
PCS2976S
|
Burning vertical outlet | Replacement of capacitor c614 47n, and modify c606 47n with the 100x35volt electrolytic cap. plus replacement of tda8177f with stv9379fa. | Maybe the tda8177f was fake, I replaced about eight. | marcioaz |
PHILCO |
TPF-2140
|
When turned on, it arms the horizontal and disarms it. and the LED is blinking | C715 of 6k8 x 1600v as low capacitance | Replace the same | gilsce |