☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 29PT554A
TV does not turn on, when it is turned on, the stand by LED flashes and does not turn on. 100uf/25v electrolytic capacitor, c2540 at the power supply with little capacitance. Replace capacitor c2540 AFONSO SANTANA
PHILIPS 20GL1045
GR1 VA 		No picture, normal sound Diode d6515 with leakage, sand castle signal ZAPELETRONICA
PHILIPS 29PT8457
L07.1L 		It works normally, but after a while of operation, if you turn it off, it won't turn on again. Stand by power supply does not fire C 2634- d6531 replace paulo eletronica
PHILIPS 20PT4331
No audio or delay for audio to appear Cap. c2444 Replace ELETROCLAUDIO AGUAS BELAS
PHILIPS 21PT9467
Darkening the image turning bluish Q09 This email address is being protected from spambots. You need JavaScript enabled to view it., jaicós PI
PHILIPS FWM570/19
Device does not work or stops working after remaining in standby. This problem may be caused by a possible short in transistor 7902, in this case, in addition to changing the transistor, the following items must be replaced: position 5930 from 100uh to 100r and position 3916 from 2k2 to 22k
PHILIPS FWM143/55
Don't open the CD drawer Cold solder on the display board at the foot of the motor cable has 1 transistor to resolder it ELETROCLAUDIO AGUAS BELAS
PHILIPS 20GL1343
Does not turn on...the ic tda8360, the horizontal square waveform from pin 37 of the ic 7200 does not come out, to excite the horizontal output...with 70 volts normal from the power supply... Does not turn on, open resistor Replacing the resistor r 3501 22k house eletronica ltda
PHILIPS 21PT6456
L03.1LAA 		No audio on the channels, but in av tsound is audio, when changing channels only the word mono (character) appeared, and without audio..stereo did not appear..sap.. No audio channel...open resistor r 3201 Resistor r 3201, open, located on pin 31 of ic 7200...tda9370.. house eletronica ltda
PHILIPS 20PT3331
Vertical closed 3 fingers bottom of the screen Change transistors smd 7461 7462 do not measure fabiusmax
PHILIPS 21PT5433
Vertical closed at the top Capacitor 2460 ( 82n) stiltec
PHILIPS 21PT6456
It turns on and off immediately, but no image, dark screen.. Diode d 6681, with leakage...so the voltage at pin 50 of the ic7200 remains at 5v, blocking the video signal and not coming out. Replace of the same .d 6681 .. house eletronica
PHILIPS 20PT4331
Connects with the channel number and not the image, when enlarging the screen it is detected vertically closed at the bottom Eprom memory Rewrite memory Eletroademar
PHILIPS 29PT4631
It doesn't turn on, it makes a strong hiss, and the LED goes off and on as if it were working, but not on high 7605 transistor, photocoupler and tea1620 The 7605 bc627 transistor was found to be broken, as a result, the device turned on but the hiss persisted. Then the +bs of the power supply was found to be low on the 6535 and 6536 diodes practically doubled, so it was just a matter of replacing the tea1620 and photocoupler and moving on. Eletroademar
PHILIPS L9.2E AA
L9.2E AA 		No image Dark screen - no image or progressive active on dvd = - check resistor 3347 (open) and diode 6343 (8v2 zener) changed, when this occurs the led blinks 12x and increasing g2 the return lines appear, the sound appears normal, measure blk (approx. 4v) if not replace the diode Check resistor 3404 alacyte
PHILIPS 14PT3131
Turning off immediately after turning on R3334 changed, q7494 burned and c2493 shorted Adjust the screen too This email address is being protected from spambots. You need JavaScript enabled to view it., jaicós PI
PHILIPS 29PT4635/78
Normal weave, but vertical, closed in half, looking like glasses with rounded lenses Deflector Djalma de Oliveira This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS 29PT6456/78
Normal league but with stripes at the top of the screen Capacitor 2456 was open replace it worked normally bira40
PHILIPS 29PT46/78
Does not turn on either through the panel or the control Tra7461 Fauez
PHILIPS 32PLF304/78
Nothing or LED turns on Cw2 and cw 4 =221/1kv shorted Bruske