Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
26PFL3404 /78
|
Interference when connected to hdmi | Check welds on: r1501, r4404, rp4404, rp4406 | Silva | |
| PHILIPS |
26PFL3404 /78
|
One of the colors in cvi is missing or has an irregular color | Cold welding ci u4201 | Silva | |
| PHILIPS |
26PFL3404 /78
|
One of the colors in cvi is missing or has an irregular color | Cold welding c1206 | Silva | |
| PHILIPS |
26PFL3404 /78
|
One of the colors in cvi is missing or has an irregular color | Cold solder r1203 | Silva | |
| PHILIPS |
26PFL3404 /78
|
Partially illuminated display | Possible leak in transformer t803, q801 and q802 - ipb | Silva | |
| PHILIPS |
26PFL3404 /78
|
Altered tone or inverted color | Check welding and dirt on the ic u4201 on the ssb panel | Silva | |
| PHILIPS |
30PF9946D/78
|
Sound with hiccups | Check welding two jumpers 9722-23-28-32/34 | Silva | |
| TV PHILIPS |
20PT 4331/78R
|
Tv with black stripe at the top of the screen | I changed the 10mf 250v capacitor and it resolved. | BF.COLATINO | |
| PHILIPS |
42PF7320
|
Doesn't start | 11 flashes on the reset board | Ic7701 sound output short (just disconnect the audio card cable and it will turn back on) | vagnernardes |
| PHILIPS |
20PT3131
L03.1L |
Burning horizontal output and heating fley back | D 6422 e but 11-afp | Replace 6422 diode and photo coupler -et103 and but 11 afp | luiztvsom |
| PHILIPS |
20PT222
|
Turns off after a few minutes. closing the image from left to right | Chap. ceramico c5445 22k located near the trans. horizontal exit | pardalzito | |
| PHILIPS |
14PT818A
U10 |
Tsound is no sign of turning on, it does not turn on and it does not oscillate. | Photocoupler | Photocoupler replace | Leomar Lunkes |
| TV PHILIPS |
29PT5642
|
Turns off when changing channels or tuning | I found that the solder was cold, tsound was a bad contact on the flyback on the ground, I did the resoldering and the TV stopped turning off | bf.colatino | |
| PHILIPS |
14PT3131
|
Power supply doesn't work | Capacitor c2564 47mfx160v | ||
| TV PHILIPS |
20GL1045
|
Top retraces | If you have this defect, you have already changed capacitors and checked everything is ok, replace the 7410 without fear. tda3653bq are champions of giving strange defects. | bf.colatino | |
| TV PHILIPS |
29PT4635
|
This 29pt turning off when turning on. I already did the ik pulse fraud and the TV stopped turning off. | As for the problem, it was resolved, but the image turned rosy. | I managed to compensate for the pink screen problem by adjusting the RGB in service mode. It also stopped turning off. | bf.colatino |
| TV PHILIPS |
21GX1666
|
I got this TV with the power supply not working (rectifier diodes, uc3842b, r3517, 6n60fi and d6519 broken). | I managed to make it work for a few minutes, but with horizontal noise, then the +95v dropped to about 65v and the +13v doesn't have it. isolating the power supply, the +95 oscillates between 92v and 96v. | The problem was on pin 2 (bad contact) on the power supply plate. | bf.colatino |
| PHILIPS |
FW-M35
|
System does not accept functions without audio | Dh46/1N4007 | Replace of the same | eletronicaapolo |
| PHILIPS |
20PT220
|
LED blinking faintly | C2550 shorted | Replace | ELETROCLAUDIO AGUAS BELAS |
| PHILIPS |
20 PT 3331/78
|
When turning on without sound, after a few minutes it came back very low | C 2444 470/16 was like 265 | irineu |