☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14231
Make Model Symptom Problem Solution By
PHILIPS 14PT418A
Does not oscillate 7540 with leak bc 547
TV PHILIPS 21PT9467/78
Turn off immediately I put the micro from another one I had sound, it wasn't cold soldering on the micro, as the TV is new. I replaced the computer and it stopped turning off BF.COLATINO
PHILIPS FWC507/19
Does not turn on panel completely off inoperative Solda fria na saida de audio Resolder transistors 7318,7305,7304,7309 and IC 7301,7302 FRANCISCO RS
PHILIPS 29PT5642/78
Doesn't start, without +b in secondary school Leaky coupler photo Swap it, if you don't have the original you can put a PC817 in, the TV works like a charm. PATRICK
PHILIPS 21PT9467S/78
SK4-0L 		Burning horizontal output, instantly. just call. Leaky flay-back for the ferrite. CARLOS MAIA
PHILIPS 14PT3336
Does not come out of stand-by, when resolved vertically closed Not coming out of stand-by 5 pin track fly and vertical micro defective Redo the track and replace the micro eletronicaapolo
PHILIPS 21PT232
Dead C2447 shorted SENPRETOR
PHILIPS 20GL1346
Little high voltage and closed vertical Transistor that powers the 8 volts of the processor IC carlao
PHILIPS 21PT232A
Null power supply secondary Ic 7520 changed SENPRETOR
PHILIPS 20PT222A
Zero power supply Short fly-back SENPRETOR
PHILIPS 14PT4131
The TV turns on and then turns off. the power supply voltage becomes unstable. Capacitor c2528 na power supply Rubens
PHILIPS 21PT5435
Changing color tone and turning off especially when the channel is not tuned Q 7463 bc 546 close to the two bds of the vertical Attention guys, replace it without measuring because in the test it says it's good antonio nobrega(patos pb)
MAGNAVOX/PHILIPS 29MT4505/78
Turning off after 10 seconds flashing After changing the two transistors bc337/25 and bc327/25+cap 47/25v, the defect persisted. The solution was to open the screen a little and the TV no longer turned off, it stayed on the whole time, but be careful; in a short time it can return to your assistance; to prevent this from happening, replace the picture tube, it is the cause of this defect. ELETRONICA SATO
MAGNAVOX/PHILIPS 29MT4505/78
Turning off after 10 seconds flashing After changing the two transistors bc337/25 and bc327/25+cap 47/25v, the defect persisted. The solution was to open the screen a little and the TV didn't turn off anymore, it stayed on all day, but be careful; it will soon be back on
PHILIPS 42PFL5332
Turns on but then turns off, the power supply keeps trying to start. Sometimes it stays on for a while but turns off again Swollen inverter capacitors (they were replaced but the defect persisted) Changing the capacitors on the inverter boards and opto changing the inverter power supply DEUNERTEC
PHILIPS 29PT5645
The TV works normally, but keeps switching off intermittently (turns off and on by itself) Diodes 6483 and 6484 open, both are bav21 diodes. WAGGUINHO
PHILIPS 29PT5645
The TV turns on and only a horizontal line appears and then turns off (vertical closed) insisting a lot, the TV turns on, but the screen remains white with retraction and reduced. 33 volts are missing from the tuning, replace the 33v zener diode even though it measures well, if it still keeps switching off, also replace the c2004. WAGGUINHO
PHILIPS 29PT4635
Burning horizontal outlet Change cap 47uf/25(2455), bcs337/25(7461) and 327/25(7463). if it continues to burn bu 4508dx put 2508dx and change drive transformer (5461) audio e video
PHILIPS 14PT3336/78R
14PT3336/78R 		Dark image and when I touched some resistors close to the 180 line, an image appeared R 3442 open R 3442 open ozenildo alves da silva
PHILIPS TV2092LVA
U16 		Starts oscillates and turns off Vertical shorted q301(stv9302a) FRANCISCO RS