Search: philips
Results: 14207
Make Model Symptom Problem Solution By
PHILIPS 29PT4641
Turning off when changing channels As incredible as it may seem, it's a cold solder on the secondary ground "pin 12 of the flyback" novaeletronicauberlandia
PHILIPS 20PT3331
L03.1L AA
Changing audio amplifier The power supply works and the voltage drops and the TV doesn't turn on. Changing audio amplifier johnny busnadiego
PHILIPS 29PT9467
Buzzing in sound As a testimonial C879 replacement DIGITAL TEC
PHILIPS 20PT122A/78R
Black band on the left side of the screen about 5cm wide pushing the image horizontally D6464 - diode in4148 shorted. The same was replaced Hunter_40
PHILIPS 42PFL5332/78
Dark image in the center of the screen and noise in the inverters U202 photo aclopador na pci power supply Replacement paulo maceio/al
PHILIPS 14 PT1352/00
L.6
LED would light up but not start C2515 47uf 200v with little capacity. 96v lows about 35v sedeug
PHILIPS 20PT3331
TV with no picture, no sound with just a white screen Ci does everything Replace ci and get fillet afonso taquari eletronica
PHILIPS 20PT120A
Vertical lines. when you reduce the brightness the lines disappear Check capacitors near the microprocessor probable cause of the defect cap.2364 Cap. 2634 ELETRONICA ROBSON(DEBIQUE)
PHILIPS 14PT3131/78R
(turns on and then off) C2444(470u/16volt) Replace c2444(470u/16v aut)located next to th Jarbas Santos (eletro-serv)
PHILIPS FDW 872
Scrambled display and inoperative device Power supply diode d961 on the 12.6v line shorted Replace the damaged diode Só Som, bakaninha o barateiro!
PHILIPS/MAGNAVOX 20MT2131
Image flickering on and off by itself 470/16v capacitor close to the flyback with low capacitance Araujo
PHILIPS 29PT4635
Turning off Clear error buffer Service mode (062596 menu) see errors then clear Edson Caeté
PHILIPS 16CT2016/16S
CTX-S
Works with light only on the bottom of the kinescope See diode d400 change also c400 has little cap. Pingo
PHILIPS 20PT4331/78
Vertical closed at the top of the screen with three mirrored lines, doubling the channel numbers (upside down) and turning off after about two hours of being turned on, but then turned back on normally. It was the C 2460 Ceramic. I replaced several vertical components and nothing was like three hours of headaches. I hadn't seen this one yet. I replaced it and it was ok. loco
PHILIPS 14PT3131/78
No audio up disappears after about three minutes Solder splash was making a jump on the smd ci connected to pin 31 of the 7200 (micro) caused by its resouda, which had cracked solders and turning off the TV loco
PHILIPS 20PT220
SONIVIDEOSVA@
No characters Resistor r 3683 (100k) aberto Bruno Nicacio
PHILIPS 20PT529
L01.2
I'm sound Cracked serial data track near the tuner (this track goes to the stereo audio processor) NelsinhoPira
PHILIPS 20GX1550/77B
ANUBIS SCC
Burning c3793b 95v ok but when turning on it burns the transistor I don't know ricardo
PHILIPS 29PT4643/78R
Dead Defective photo-coupler Jaison
PHILIPS 20GL1340
Loses tune momentarily Changed the tuner Jaison