Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
20PT120B
L7VA |
The LED comes on and it keeps flashing and the TV doesn't work | Change c2448 and 2551 both 47/160v | CHARLES CIPRIANO | |
| PHILIPS |
14PT3131/78
|
Closing the vertical | Capacitor 68.n 250v | I replaced this capacitor and the TV worked normally | gabriel |
| PHILIPS |
29PT5642/78
|
Normal image but with lines superimposed on the image | R 3468 open | Vilmar | |
| PHILIPS |
21PT9467
|
Blue screen with retrace lines, normal sound without image | Swap rgb q502 and q503 transistors | ||
| PHILIPS |
14GL-1316
GR1-VA |
Don't tune in | Verificar r3961 / r3962 / r3963 (10k) | Replace the resistors | johnny busnadiego |
| PHILIPS |
20GL1049/78R
|
Dead | Flyback at2079/b9 burst | Jaison | |
| PHILIPS |
29PT5642/78
|
Image a little dark | R 3451 of 68k open | Daniel | |
| PHILIPS |
14PT3131
L03.1L |
In AV it works normally and on TV the image appears and turns off | Change the r3449 33k open on some TVs the resistor is 27k | resistronic | |
| PHILIPS |
21PT9467C/78
|
Retraces, with white lines, intermittent turning off and on | Coil l-501 aberta | samuel leite | |
| PHILIPS |
29GX1895
ANUBIS S |
Does not exit demo mode | Ground pin 20 of the micro | With the TV turned off, ground pin 20 of the computer and turn on the TV, an image with drizzle will appear, then turn off the TV, remove the ground and that's it. | johnny busnadiego |
| PHILIPS |
-TFT 170S
A3KM118 |
Monitor does not start. | Replacement of 25v/470u capacitors 2117, 2118 and 25v/220u capacitor 2122 | Look for the schematic in the monitors section. | batraquio |
| PHILIPS |
14GL1013
|
Without tuning, vhf channels blocked all on vhf prim.emiss.de and uhf on uhf prim.emiss. | Check power line. which goes from pin 1 of the computer to the selector. | Open 10k 3962 resistor. | ELETRÔNICA ESTUDIER- CANOAS-RS |
| PHILIPS |
GL1316
|
High power supply | C2347 e c2346 valor 47*160 | dede som | |
| PHILIPS |
21PT232
L7 PLUS |
Does not turn on, normal power supply, standby LED blinking | Eeprom with corrupted data | Rewrite the eeprom | alexsts |
| PHILIPS |
CDC 265
|
Display or viewfinder off | Burned out lamp | edinho | |
| PHILIPS |
AZ1134
|
Cd doesn't work | Smd capacitor on 8v supply with leakage | Rubens | |
| PHILIPS |
20PT3331
|
It doesn't turn on the power supply ok, it doesn't oxilate s.h. | C2429 = 220n with leakage connected to the t7423 emitter | Bruske | |
| PHILIPS |
20PT524A
|
Does not activate | Fly back/trans.sh collector pin with 34v when you open this pin or pin 1 and 2 of the fly back the voltage goes to 98v. | lpinheiro | |
| PHILIPS |
29PT552
|
Burning the vertical outlet | Place a wire from the deflector clamp to the ground of the tube | Replace the capacitor c2404 of 100p, 22k put the diode cathode on pin 5 replace r3488 from 4.7 to 5.6 and great | miltom |
| PHILIPS |
20GL1045
|
Just the sound (increasing the screen the image is flat) | C 2140 100ufx25volts capacitor no apagamento vertical | HP ELETRONICA |