Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
20PT3336
L03.6L |
Power supply overheated, colors fluctuated and turned off | Capacitor 2503 | Reginaldo | |
PHILIPS |
20PT3331
|
I'm sound | Test 1: if the sound reaches the sound output, disconnect pin 9 from the output, if the sound is loud, replace the smd 6908 zener diode... test 2: if the sound does not reach the sound output, just reconnect one tweezers, with the TV on high volume, shorting out the caps. smd 2201 and 2202 are close to pin 31 of the processor, which outputs sound you change. good luck | In my case, I did test 2, and it was the smd 2202 cap. | SYSTEM ELETRONICA JUNIOR |
PHILIPS |
29PT5642/78R
|
Vertical, with three colored lines at the bottom of the screen | Diodo smd 6457, l0mfxl00v e 100mfx50 | eduardo | |
PHILIPS |
PIPO 14GL1319
|
Has sound and no image | Open resistor r3020 16k | Replace it and it's ok. good luck | eletroclaudiope |
PHILIPS |
29PT4635/78
LO1 |
This TV arrived at the workshop with the vertical closed. the resistor in position 3479 of 2k7 open, was the cause of the problem. I replaced this resistor, and the device started to work normally for a few hours, until I noticed that the screen darkened and brightened slightly and then, it darkened once and for all, leaving the sound and normal OSD. After researching a little more, I found the smd transistor in position 7204 shorted. Once this resistor was replaced, the device started working normally again. | The 2k7 smd resistor in position 3479 open, was the cause of the closed vertical. the smd transistor in position 7204 bc857b, responsible for dimming the screen. | jfr | |
PHILIPS |
14PT110A
|
It doesn't turn on, if you enlarge the screen, retrace lines appear | Replace saida vertical tda3653b | MB ELETRONICA | |
PHILIPS |
20PT428A
|
The device is switched on, after a few seconds dark ripples appear horizontally, and the device switches off. | Electrolytic capacitors: 2561 and 2409, both 47uf x 160 v. located at the power supply, replace them, it will be ok. | Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, JATAÍ-GO, |
|
PHILIPS |
29 PT 4635/78
|
Horizontal line to your right only with weak signal, with barabolic signal and av all normal | In my case I changed the transistors: q7461 and q7463 | Replace q 7461 and q7463 bc 337 and bc 327. good luck! | ELETRÔNICA JUCÁ |
PHILIPS |
21PT5433/78R
|
Dead | Transistor 7423 (bc807-25) | Replace of the same | Bomtempo Mecatrônic |
PHILIPS |
20GX1656
ANUBIS |
Jagged image | Change c2451 | Eletronica Avila | |
PHILIPS |
29PT4643
|
Shutting down followed by error code 11 | Defect in tda6107ajf | klein | |
PHILIPS |
20PT3331/78
|
Power supply starts to oscillate and stops | Pin 54 of tda9370 killing 3.3v voltage | Replacing the computer and memory | |
TV PHILIPS |
29PT4635
|
Sources everything ok but won't leave the stand bay | One of the keys on the manual control stuck | Check check keys | moroni eletronica |
PHILIPS |
14PT314B/77B
|
When I show the TV it lights up from the middle to the top without sound or image | The power supply voltages are normal in the micro, the reset reads 0 volts. I don't know if it is normal. I don't have the diagram. | ||
PHILIPS |
21PT534A/78R
L9.2A |
Turns off after a few seconds | Dt43 (21 Btkha4a/Hdr) | Replace directly "plate position correction" | MORAES SPTV CAMPINAS |
PHILIPS |
21PT534A/78R
L9.2A |
Turns off after a few seconds | D6443 (bzx284c8v2) | Replace directly | MORAES SPTV CAMPINAS |
PHILIPS |
14GL 1019
GR1-L1 |
Stop | C2351 220mf, 16v supply filter | Replace. | e-mail: |
PHILIPS |
14PT3131/78
|
Turning off, power supply oscillates between 35v and 65v +b | Photocoupler | Photocoupler replace | beto2828 |
PHILIPS |
21P9467
L04K |
Horizontal fallen | 4k7 ceramic capacitor | Replace c208 connected to pin 17 of the processor and be very happy with the tip from itan parelhas, rio de janeiro (head | |
PHILIPS SOM |
FWM185/BK
|
Does not read cd and usb | Q203 | Replace without testing |