☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14207
Make Model Symptom Problem Solution By
PHILIPS 14GL-1316
GR1-VA 		Don't tune in Verificar r3961 / r3962 / r3963 (10k) Replace the resistors johnny busnadiego
PHILIPS 20GL1049/78R
Dead Flyback at2079/b9 burst Jaison
PHILIPS 29PT5642/78
Image a little dark R 3451 of 68k open Daniel
PHILIPS 14PT3131
L03.1L 		In AV it works normally and on TV the image appears and turns off Change the r3449 33k open on some TVs the resistor is 27k resistronic
PHILIPS 21PT9467C/78
Retraces, with white lines, intermittent turning off and on Coil l-501 aberta samuel leite
PHILIPS 29GX1895
ANUBIS S 		Does not exit demo mode Ground pin 20 of the micro With the TV turned off, ground pin 20 of the computer and turn on the TV, an image with drizzle will appear, then turn off the TV, remove the ground and that's it. johnny busnadiego
PHILIPS -TFT 170S
A3KM118 		Monitor does not start. Replacement of 25v/470u capacitors 2117, 2118 and 25v/220u capacitor 2122 Look for the schematic in the monitors section. batraquio
PHILIPS 14GL1013
Without tuning, vhf channels blocked all on vhf prim.emiss.de and uhf on uhf prim.emiss. Check power line. which goes from pin 1 of the computer to the selector. Open 10k 3962 resistor. ELETRÔNICA ESTUDIER- CANOAS-RS
PHILIPS GL1316
High power supply C2347 e c2346 valor 47*160 dede som
PHILIPS 21PT232
L7 PLUS 		Does not turn on, normal power supply, standby LED blinking Eeprom with corrupted data Rewrite the eeprom alexsts
PHILIPS CDC 265
Display or viewfinder off Burned out lamp edinho
PHILIPS AZ1134
Cd doesn't work Smd capacitor on 8v supply with leakage Rubens
PHILIPS 20PT3331
It doesn't turn on the power supply ok, it doesn't oxilate s.h. C2429 = 220n with leakage connected to the t7423 emitter Bruske
PHILIPS 20PT524A
Does not activate Fly back/trans.sh collector pin with 34v when you open this pin or pin 1 and 2 of the fly back the voltage goes to 98v. lpinheiro
PHILIPS 29PT552
Burning the vertical outlet Place a wire from the deflector clamp to the ground of the tube Replace the capacitor c2404 of 100p, 22k put the diode cathode on pin 5 replace r3488 from 4.7 to 5.6 and great miltom
PHILIPS 20GL1045
Just the sound (increasing the screen the image is flat) C 2140 100ufx25volts capacitor no apagamento vertical HP ELETRONICA
PHILIPS 20PT3336
L03.6L 		Power supply overheated, colors fluctuated and turned off Capacitor 2503 Reginaldo
PHILIPS 20PT3331
I'm sound Test 1: if the sound reaches the sound output, disconnect pin 9 from the output, if the sound is loud, replace the smd 6908 zener diode... test 2: if the sound does not reach the sound output, just reconnect one tweezers, with the TV on high volume, shorting out the caps. smd 2201 and 2202 are close to pin 31 of the processor, which outputs sound you change. good luck In my case, I did test 2, and it was the smd 2202 cap. SYSTEM ELETRONICA JUNIOR
PHILIPS 29PT5642/78R
Vertical, with three colored lines at the bottom of the screen Diodo smd 6457, l0mfxl00v e 100mfx50 eduardo
PHILIPS PIPO 14GL1319
Has sound and no image Open resistor r3020 16k Replace it and it's ok. good luck eletroclaudiope