Philips Repair Tips
Search: philips
Results: 14207
Results: 14207
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
21PT5433/78R
LO3 |
How to enter the service without credit | On the board tsound is sdam 9257 and a j sdam 3606 r 10k short circuit from j to the resistor when the TV turns on remove the short immediately it is in service mode | ||
PHILIPS |
29PT4643/78R
|
Vertical rolling top | R 3464 or 3465, the original only had a 220r resistor that was changed to 260r | Just replace and run to the hug. (62) 3315 3892. | Eterno Videotron |
PHILIPS |
14PT3336/78R
|
(dead) | R3445(1r)next to fleybak | Replace r3445(1r) next to th | Jarbas Santos (eletro-serv) |
PHILIPS |
20PT326A/78R
|
Non-functional inoperative. | But11apx shorted. | Replace but11apx with the original or but12af if it won't burn horizontal output. | celinvds |
PHILIPS |
14PT3336/78
|
(dead) | R3445(1r) | Replace r34445(1r) next to th | Jarbas Santos (eletro-serv) |
PHILIPS |
FWM589
|
Doesn't start | Replace c2909 | C2909 470n replace | domigos sp |
PHILIPS |
14PT3131
|
Turns on the image appears and then turns off | Defect was found in the rgb pci of the tube | In my case it was the transistor 7318(bf423) short and the resistor 3318(220r) open tip check them all. | eletronica fernandes |
PHILIPS |
29SX8879
|
Doesn't turn on, no +b | R 3138 33k aberto | Master Eletronica | |
PHILIPS |
PT3336
|
I'm sound | E-pron | juvenal-picos-pi | |
PHILIPS |
DVP3142KM/78
DVD |
He left | Change resistor r76 dvd returned normal | ||
PHILIPS |
21PT6437
|
Fully closed vertical | Ra 445 | Replace r3445 of 1r 1/2w tv came back normal | |
PHILIPS |
20PT228A
|
TV without video and sound | D 6405 | Replace diode d6405 | |
PHILIPS |
20PT326A/78
|
Turns on, standsby but tsound is no image, when changing channels the LED flashes but tsound is no brightness on the screen. | Adjust the flyback screen, if it is off the screen does not light up | Eronaldo | |
PHILIPS |
20GL1346
GR1-VA |
When turning on no image, no sound. with filament. when increasing the screen it only gave a return trace | C2410 100/25v with low capacitance close to the vertical ci | After replacing it, the TV was ok | Jose Gusmão |
PHILIPS |
20PT3331
|
When turning on, 3 lines appear at the top with the image closed a little and then it turns off | Capacitor poliester c2460 de 68k/250v | José Gusmão | |
PHILIPS |
20PT3336
|
It would turn on, after a few seconds it would turn off, the channel number would be streaked | I changed the photo coupler, it was ok. | wilhelm | |
PHILIPS |
VR 788
|
When inserting the VHS tape, it pulls and turns off. | The head cylinder does not rotate. | Oxidation on the board, measure and make a jumper. | azaujotec |
PHILIPS |
29PT4631/78R
|
When turning on the TV, the image appears with aliasing and a slightly reduced horizontal, then it turns off and when turned on again, the TV works normally. | Capacitor c2455 47mf25v with low capacitance. | Replace for another one, but you can put a 47mf 50v one | ROBERTO |
PHILIPS |
TP4635
|
Turns on, turns off and on the screen it appears when the horizontal trident is broken but it doesn't have it | I just had to change the electrolytic capacitor 2455 47x50 eos transistor 7461bc337 and 7463bc227 and run to hell | atonio | |
PHILIPS |
21PT534
|
When turning on the LED flashes once and returns to standby | 3470 open resistor | eletronet |