Philips Repair Tips
Search: philips
Results: 14207
Results: 14207
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
29PT4635/78
|
TV turns on with retrace lines and after a few seconds it turns off | 3494 open resistor | Replace resistor e ic do rgb 7330 | taquari eletronica |
| PHILIPS |
29PT4635/78
|
Vertical half closed | Oxidized tube coil | In my case, I disassembled it and spliced the wire that oxidized | luischapinoti |
| PHILIPS |
20GL1346
|
Image just the frame without definition in the image | I checked the power supply was normal so I checked the value of r3248, when the ci 8361-3y the resistor is 47k, if it is 8361-5y or 4x the resistor is 8k2 ok? | JUVENAL PICOS-PI | |
| PHILIPS |
21PT6456
|
Burning but 11apx | I replaced it with another of the same value and it burned... I think it was of very poor quality. | I put the bu1508dx in its place and it worked beautifully without getting hot. | ELETRONICA SÃO FRANCISCO - BARRAS - PI |
| PHILIPS |
29PT5645
LO4U |
Does not turn on, nor does the stand-by LED light up | Tea1620 and r3532 of 4r7 and r3538 of 1r8 smd yes cast iron | Replace the same ones for new ones | eletroclaudio aguas belas |
| PHILIPS |
29PT6456
LA |
Vertical closed | Shorted smd 6457 diode | edtv | |
| PHILIPS |
20PT529A
|
Does not turn on, does not light up, the inoperative LED | Coupler | Replace the same one for a new one | eletroclaudio aguas belas |
| PHILIPS |
14PT3336
L03.6L |
Turns on the image appears and turns off in 5 seconds | Open 10k resistor r3475 | eletroclaudio aguas belas | |
| PHILIPS |
21PT5433
L03.1 |
Turns it on and before the image appears it turns off the LED and it won't turn on again, just unplug it. she returns and repeats the same procedure | Defective tube socket | Replace the same one for a new one | eletroclaudio aguas belas |
| PHILIPS |
20LG1049
GR1-R03 |
Reduced image without synchronization | Crystal 3.58 plastic format | Crystal replace | GENIVALDO |
| PHILIPS |
29PT9467
|
Turns on normally with sound, lights up filament, without screen voltage and without image | Leaky pipe socket | Bruske | |
| PHILIPS |
29PT552A
L9-LLS |
LED keeps oscillating, turns on, doesn't turn on | Vbat voltage too high | Changing the two capacitors, c2450 and c2551, 47/160v, the TV was awesome | ffeet |
| PHILIPS |
29PT458A/78
* |
Works normally after 2 hours and turns off loudly with 3 vertical lines, after it turns off the first time it goes away. | I replaced the socket with someone else's information, and it was fine. | Your replace | wagner |
| PHILIPS |
20PT4331
L03.1L |
Totally unfocused image showing 3 blurred colors (green, blue, red) implying that it's a socket | Q7463 bc546 short between collector and base | Replace the q7463 tv got a 10 | JOSÉ GUSMÃO |
| PHILIPS |
14PT316A/78R
|
Power supply does not work, oscillating | Chap. 2530 and 2540 at power supply | Replace both ok. | fabiusmax |
| PHILIPS |
14GL1316/78R
|
No image, no OSD, normal tube, normal filament just doesn't show up in the image. | In 7207 TDA4661 Ruim. | Replace ci 7207 tda4661 | PALAURO |
| PHILIPS |
28PT800A
FL1.17 |
Does not start. red display on. protection activated | See line transformer, diode 6536 (byw29f) and smds 7541, 7541, 7542 | Divercentro | |
| PHILIPS |
20PT228A
LO1.2L. |
Tv turning off | R.3417 . open. | geraldo eletr.c.grande | |
| PHILIPS |
21PT6446/78
|
Vertical with closed top and three colored lines | Electrolytic capacitor 2464 and 2465 with low capacitance | Replace them | eletrônica BRITO |
| PHILIPS |
21PT8467
|
Vertical fechado | 3445 open 7463 shorted |