☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14207
Make Model Symptom Problem Solution By
PHILIPS 20PT3336
Don't turn on speaker jumping like a beating heart Open 1r resistor 3445 Replace eletroclaudio aguas belas
PHILIPS 20PT9467C
Don't turn on speaker jumping like a beating heart Open 1r resistor 3445 Just replace eletroclaudio aguas belas
PHILIPS 20PT9467C
Don't turn on speaker jumping like a beating heart Open 1r resistor 3445 Just replace eletroclaudio aguas belas
PHILIPS 21PT534
L9.2 		Without video with audio and then turns off Transistor com flake kinescopio board Q7313 q7323 q7333 r3347 GENIVALDO
PHILIPS 29PT656
A10 		Does not come out of standby Defect in the softer board that is outside the main board This board is not available on the market Sergio Luiz
PHILIPS 25PT 848
L01 1LAA 		Turning off after about 2 minutes Screen adjustment Sergio Luiz
PHILIPS PT4131
Turns on but vertical does not open 7491 change directly if the voltage on pin 14 of the computer is not 8v junior
PHILIPS 14PT519A/78
Channel skipping C2606 no pino 80 do ic7200 Osmildo J Silva. Pontes e Lacerda MT
PHILIPS 14 PT
Dark picture with/normal sound Open resistor r3425 change and that's it, blz
PHILIPS 21PT4533
Turns it on and before the image appears it turns off the LED and it won't turn on again, just unplug it. she returns and repeats the same procedure Defective tube socket Replace the same one for a new one eletroclaudio aguas belas
PHILIPS 20PT3336
When turning on the TV you notice that it generates high voltage but then turns off without lighting up the filament The filament track on the tube plate was broken I redid the TV track, it worked normally This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS 21PT467/78
Vertical closed normal output 1st open resistor 3445 Replace and run for the hug Sebastião Nedina
PHILIPS 29PT552A/78R
LED blinks and the TV does not turn on, the power supply and voltages are ok but the TV does not oscillate, it does not generate high voltage. C2457 470nf dry, at the output of the horizontal coil, I replaced it and it worked.
PHILIPS 29PT9467
Preso em stand-by L105 open, ic201 in reset renato tranca forte
PHILIPS 21PT9467
Vertical closed and circulating from the middle to the top to the top and stays stinging like a fluorescent to light C316 r310 r318 open and the vertical output ic351 tda4865aj and d304 and d305 shorted Replace them all eletroclaudio aguas belas
PHILIPS 21PT438/538/29PT558/658
LO1.1L.AA 		Lines at the top C2476-2k7 - + scrape glue underneath milton
PHILIPS 21PT438/538/29PT558/658
LO1.1L.AA 		Lines at the top C2476-2k7 + scrape glue underneath milton
PHILIPS 14PT3131/78R
Turns on with vertical stripes and turns off Broken trail Call (j9518) to (c2447) resolved NILTON-AVARÉ-SP
PHILIPS 14PT110
When you press the channel, the LED blinks a few times and it doesn't turn on Resolder c 2442 or replace it (the same and smd) ANTONIO NOBREGA [PATOS.PB]
PHILIPS 29PT5408/01
L04E.AA 		It only worked for a few seconds. The LED blinked 5+11 times. Trc with unbalanced gain. Cleaning the cannons (rejuvenation) and it was ok. Cunhas