Philips Repair Tips

Search: philips
Results: 14207

Make	Model	Symptom	Problem	Solution	By
PHILIPS	20PT3331	Totally inoperative	Saturate. Saida Horintal	After changing. horizontally, the TV turns off after 5 s. Then I just adjusted the screen and everything went back to normal	ROMILDO
PHILIPS	29PT554A	Dark screen with retrace lines (normal sound), actuating the screen only increases the retrace.	R3340 pci do cinescopio		py3ig
PHILIPS	21PT9647	Turns on normally but after three seconds returns to stand-by	18v zener diode shorted (zd 303)	Replace it	eletrônica BRITO
PHILIPS	21GL1369	Normal image but all red, blue, or green.	Swap the three RGB output transistors.	Ok	This email address is being protected from spambots. You need JavaScript enabled to view it.(floripasc)
PHILIPS	21PT5433	Works for approximately 10 seconds and turns off	Fleibk desk tripod malfunction		ildefonso
PHILIPS	25PT5536	Blue screen retrace line	Tube with shorted grid	Knock slowly on the neck of the tube/when it comes out, it doesn't come back	ladmyr
PHILIPS	20PT3331	Do not connect the power supply transformer making noise and the power supply does not arm	Horizontal output shorted bul312p I changed the function but it got hot until it burned, the fly back iron was broken, the ferrite was out of place	Replace the sound and place another iron to hold the ferrite	eletroclaudio aguas belas
PHILIPS	29PT4635 L01.1L	1 it didn't turn on, 2 it turned off as soon as the image appeared	1 tr smd pdtc143 posiçao p.c.i 7462 / 2 tr smd posiçao p.c.i 7450		Magayver
PHILIPS	20PT4331	Screen with vertical closed about 10 centimeters at the bottom	Enter service mode and VSL, which is 33, was zero, increase it to 33 or rewrite or change the eprom		eletroclaudio aguas belas
PHILIPS	21GX1666	TV had a reduced frame in both hor/vert	C2531 47uf 160v, like low capacitance
PHILIPS	PT 2078	TV stays on stand by doesn't turn on, doesn't arm goes back to stand by	C2551 160v 47uf	I replaced it and I'm new	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT5437/78	Dark screen with osd	R3442		DANIEL SOLÂNEA PB
PHILIPS	20PT122A/78	TV with audio and no brightness (dark screen)	Tsound is no voltage vg2 that comes from the line graph	Replace the line transformer 0v2094/41	samuel leite
PHILIPS	20PT120	Works normally after a few seconds reduces the frame and lowers the power supply voltages	Mc-44630ap	Replace	Frighetto ALT SAT (66) 3534-1716
PHILIPS	PT3331 L03.1L		Help other colleagues		Valfredo Lima
PHILIPS	21PT6456	Sound on bad tv, normal av	Stereo did not identify the channel, in normal av	C 2205 10μF	www.rmeletronica.com.br
PHILIPS	14 POLEGADA	Fuse is blowing	A diode in the power supply	And just test all diodes in the power supply	jerfeson
PHILIPS	ALGUNS MODELOS	Activation of the protection circuit due to a momentary loss of mains power or protection acting at the initial moment of starting	Solution add a 22nf 25v smd capacitor in position 2452		milton
PHILIPS	CHASSIS LO1	Device turns off suddenly	The horizontal exciter circuit of this device is carried out by a pair of transistors bc337-25 and bc327-25, replace these two even if they are measuring good, note the 25 that corresponds to hfe	Replace the capacitor between collector and emitter of npn 337 -25	milton
PHILIPS	14 GL1010 GR1 AL	When it's cold it doesn't work	C 360, c361, c351 sold out		CALIXSERVICE