Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
TV PHILIPS	29PT5642	Turns off when changing channels or tuning	I found that the solder was cold, there was a bad contact on the flyback on the ground, I did the resoldering and the TV stopped turning off		bf.colatino
PHILIPS	14PT3131		Power supply doesn't work	Capacitor c2564 47mfx160v
TV PHILIPS	20GL1045	Top retraces	If you have this defect, you have already changed capacitors and checked everything is ok, replace the 7410 without fear. tda3653bq are champions of giving strange defects.		bf.colatino
TV PHILIPS	29PT4635	This 29pt turning off when turning on. I already did the ik pulse fraud and the TV stopped turning off.	As for the problem, it was resolved, but the image turned rosy.	I managed to compensate for the pink screen problem by adjusting the RGB in service mode. It also stopped turning off.	bf.colatino
TV PHILIPS	21GX1666	I got this TV with the power supply not working (rectifier diodes, uc3842b, r3517, 6n60fi and d6519 broken).	I managed to make it work for a few minutes, but with horizontal noise, then the +95v dropped to about 65v and the +13v doesn't have it. isolating the power supply, the +95 oscillates between 92v and 96v.	The problem was on pin 2 (bad contact) on the power supply plate.	bf.colatino
PHILIPS	FW-M35	System does not accept functions without audio	Dh46/1N4007	Replace of the same	eletronicaapolo
PHILIPS	20PT220	LED blinking faintly	C2550 shorted	Replace	ELETROCLAUDIO AGUAS BELAS
PHILIPS	20 PT 3331/78	When turning on without sound, after a few minutes it came back very low	C 2444 470/16 was like 265		irineu
PHILIPS	29PT4635	Doesn't start	Horizontal outlet burnt out, I replaced it and it burned out again	Replace do bu4508dx, capacitor driver c2456 2,2μF/100v, transistor t7461 bc337 e t7463 bc327, capacitor c2455 47μF/25v.	eletronica fernandes
PHILIPS	29PT4631 L01.1LAC	Low power supplys, mainly 10v	Defective transistor 7462	Pdtc143zt transistor replaced	johnny busnadiego
PHILIPS	21PT6456	With sound, without image with dark screen, menu and normal characters	R3442 open		eletronicard
TV PHILIPS	29PT554A	The device was completely stopped,	After putting it to work, (I changed the SAA processor) the TV came with SDM mode activated	It was the grounding of pin 1 of the eeprom that I had made myself and forgot to remove it.	BF.COLATNO
TV PHILIPS	21PT5435	This TV is activating closed cap cc1 without being activated by the user.	Enter the menu, and do not switch to any cc mode. put it off. I turned it on now and went into the menu there is cc1/cc2/cc mute/cc no, I leave it on cc, not when I turn it off using the remote control or the main switch that I turn on already has cc activated	Record this one. http://www.4shared.com/file/x9fg1do2/21pt5435_24c16.html I saved the memory not active now it is resolved.	BF.COLATINO
TV PHILIPS	20PT220A	This TV, it didn't have an image just the sound, I resoldered the tube board and the image appeared but it is very stretched and the screen is full of lines.	To resolve this defect further, I replaced the r 3414 and 3418 and resoldered several parts of the TV.		BF.COLATINO
TV PHILIPS	29PT4635	This TV arrived, with the bu 4508dx shorted out, I replaced it but it didn't turn on, it has the following problem, as soon as I plug it into the network, the LED turns on and the second time the noise starts, tenc tenc tenc very quietly, when you press the Power on the control, it turns off the LED and the rereader stays tec tec tec direct and not ocilia, I already replaced the 2455 47uf25v,6490 the bcs 7461 bc337 7463 bc327 ci 7560 l78l33a the ci coupled with the 817 all new I tested both bd they are good	Resolved. The TV didn't turn on at all, it was the bu 4508dx that had a short circuit after changing the bu, the TV turned on and the LED didn't light up, the defect was the smd zener diode bzx384-c9v1o. shorted to position 6541.		BF.COLATNO
TV PHILIPS	29PT5642	This TV only has voltage up to the 170v MOSFET drain, the transformer's secondary has no voltage, indicating that the def must actually be there.	Defect was the photocoupler		BF.COLATNO
PHILIPS	14PT110 A	Does not turn on and the LED keeps flashing	Fly back defect		klein
PHILIPS	25PT5541 L04U AA	Does not turn on, no secondary voltage, no LED lights up	Raakh 13		johnny busnadiego
PHILIPS	25PT5541 L04U AA	Does not turn on, no secondary voltage, no LED lights up	Review r		johnny busnadiego
TV PHILIPS	29PT552	Defect: shutter effect, lower vertical	Solution: capacitor c2409 changed 0.22 x63v		BF.COLATINO