Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	14GL1015	Image out of tune	Touch tda8360		silva2
PHILIPS	16GL1332	Blurred image	Bad flyback causing the burning of r522,555,556,c556, these components worked normally but with a blurred image without contrast considering the damaged ts557.	Replace sem mdir ts557 bc558	PALAURO
PHILIPS	20PT3336	Turns off as soon as the image appears, you notice colored shadows on people	Weak tube.	Replace tube	tyko
PHILIPS	21GX1668/78R	Volume increases to half and freezes characters	Memoria eeprom	Replace	afonso
PHILIPS	14PT314A L9.2A	Tda9302h getting hot when changed.	Replace capacitors c2465, c2466 and c2467 with new capacitors with higher insulation voltage in the case of 100 volts. There's no point in measuring, you have to change it.		jedvaldo
PHILIPS	21PT8467	TV has audio and also sound in AV. but no sound with varicap input	Change eproom, in this case, at 24c16 wp. hugs ...		POLYSOM
PHILIPS	DVD625/782	It doesn't turn the disc, it tries to start but then stops.	This device causes a lot of problems with the 2 motors, the spindle and the charging one, check them both on the 1Ω scale of the miter, they have to give 100Ω or more if they do, they are good, then you can check the flat if it is old with a lot of bending, change it, also at mpeg board a c8 capacitor, I hope I helped you!!!		apdo - ardldvd
PHILIPS	29PT5642/78	Vertical closed position with three colored lines at the bottom of the tube, in 15 seconds the protection was activated	Diodo d 6457 capacitor c2463(100uf 50v) c2465 (10uf 100v)		lucio This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	20PT5294 /78	Stopped .dead power supply	Bad tea1507 I changed it, solved it		ELETRONICA IDEAL
PHILIPS	20PT3331	Turning on and shortly after turning off with upper lines and partially closed at the top	The polyester capacitor measuring 683k x 250v, or 100 nanofarads x 250v, it was measuring around 17 nanofarads, its location on the board is c2460 close to the flayback	As a precaution, also replace the following capacitors .c2465, c2446, c2444, c2463, c2405, c2564. without testing thanks guys	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	25PT5541 L04	No sync	Replace capacitors 2235 and 2236		johnny busnadiego
PHILIPS	21PT5433	Vertical opens only half and with retraction lines at the top	Change the 6460 diode		MACCELETRONICA
PHILIPS	29PT5642	Retraces lines and turns off	This TV, when turned on, showed lines of retraces across the entire screen and then turned off. when measuring r 3351(100r), it was open and the ic 7330(tda6107) was shorted, with the replacement of these components the tvc returned to normal operation.		Sebastião
PHILIPS	28PT4438/01 L01.1E AA	Does not turn on or show a signal on the LED s/by	Photocoupler with passage in the diode part	Replace the same	Antonio Fernandes
PHILIPS	21PT5435	Normal sound normal osd with dark screen	Check r3441 r3442 100k open next to the fly	In my case it was only r3442 of 100k	color tec
PHILIPS	14PT113	No characters	100k open resistor 3683	Replace	eletroclaudio aguas belas
TV PHILIPS	20GL1344/78Z	Tv with retrace	R3350 3,3 r		Marcone
PHILIPS	20PT120A	TV does not turn on, pulsing the LED 5 times, replacing the epron and there was no success	Solution replace fly back		Carlos Guerra
PHILIPS	29PT554A	Horizontal black stripes at the bottom of the screen	C2409		Manoel
PHILIPS	14GL1314	Device without sound. with write-off no. 3 of ci 7600.	No pino 5 do ci7200 com 0v.	R 3219=22k,open. good luck!	pernambucano