Search: philips
Results: 14210
Make Model Symptom Problem Solution By
PHILIPS 14PT 519A
L01-2L
Turns off after 5 seconds After switching on, the image appears ok and then turns off Photocoupler replace johnny busnadiego
PHILIPS 29PT 4643/78
When you turn on the TV, 3 colored lines appear, opening the screen, closing an upper part with horizontal retrace lines doubling the image. Vertical deflection with low capacitance. Replace the electrolytic capacitor 2465. 10 micro x100v. Valdir - Cajamar
PHILIPS 21PT6456
Vertical closed buzz on flyback Replace 3445 1r resistor R 3445 open Aliomarp
PHILIPS 20PT3331
Turns on then turns off shaking the board Photo coupler julio itaguai
PHILIPS 14GX1618
Doesn't tune in to all off-air channels R3650 15k Replacelo ANTONIO NOBREGA [PATOS.PB]
PHILIPS 20PT3331
L03.1L AA
No sound Capacitor 2444 Swap c 2444 NARDINHO- ALFENAS
PHILIPS 21GX1669
Turns on and goes into protection D6585 shorted, r3585 and r3586 open ARAUJO
PHILIPS 21PT9467C/78
Vertical closed at the top Diode d351 open fabiusmax
PHILIPS 29PT4636/78R
High power supply.does not turn on Power supply Caps do sec.bc337,327.tsh F.Gil
PHILIPS 21PT5,37/78
When it turns on it makes squeaking and clicking noises and turns off When it turns on it makes squeaking and clicking noises and turns off jose wilson
PHILIPS 29PT5642
L04U AA
Vertical folded and short at the top When turned on, 3 colored stripes appear and after the TV opens the image the vertical one is short and bent Troque o capacitor 2465 10x100v Eletroinfo
PHILIPS 14PT3131
When this TV was cold it wouldn't turn on, it had to be warmed up first so that the image could appear, apparently being a capacitor or transistor. The photo coupler while it was cold presented the defect when it heated up the defect disappeared and the TV worked, Replace eletroclaudio aguas belas
PHILIPS 29PT4635/78
TV turns on with retrace lines and after a few seconds it turns off 3494 open resistor Replace resistor e ic do rgb 7330 taquari eletronica
PHILIPS 29PT4635/78
Vertical half closed Oxidized tube coil In my case, I disassembled it and spliced ​​the wire that oxidized luischapinoti
PHILIPS 20GL1346
Image just the frame without definition in the image I checked the power supply was normal so I checked the value of r3248, when the ci 8361-3y the resistor is 47k, if it is 8361-5y or 4x the resistor is 8k2 ok? JUVENAL PICOS-PI
PHILIPS 21PT6456
Burning but 11apx I replaced it with another of the same value and it burned... I think it was of very poor quality. I put the bu1508dx in its place and it worked beautifully without getting hot. ELETRONICA SÃO FRANCISCO - BARRAS - PI
PHILIPS 29PT5645
LO4U
Does not turn on, nor does the stand-by LED light up Tea1620 and r3532 of 4r7 and r3538 of 1r8 smd yes cast iron Replace the same ones for new ones eletroclaudio aguas belas
PHILIPS 29PT6456
LA
Vertical closed Shorted smd 6457 diode edtv
PHILIPS 20PT529A
Does not turn on, does not light up, the inoperative LED Coupler Replace the same one for a new one eletroclaudio aguas belas
PHILIPS 14PT3336
L03.6L
Turns on the image appears and turns off in 5 seconds Open 10k resistor r3475 eletroclaudio aguas belas